DigiTech RP1000 Connection Setups

Loop:  (post Distortion, pre Amp Model/Amp Loop send), or (Post

Amp Model/Amp Loop return). Note that the Stomp Loop button’s LED turns red when

it’s pre amp, and green when it’s post amp or post FX.

Store these changes using the Store procedure.4.

Note: If you try to enable the Stomp Loop but nothing is connected to the Stomp Loop jacks,

the Display will brieﬂy read . The Stomp Loop will not enable when no connections

are present at these jacks.

Connection Setups

The RP1000 has many different connection options. Here are some more common ways it can

be used:

Mono Amp

Connect your guitar

to the RP1000’s Input.

Connect the RP1000’s

Left (mono) Line Output

to the amp’s Input.

Amp/Mixer switch on 1/4"

outputs is set to AMP.

Contents

Main Page Table of Contents Section One - Introduction ............1 Section Two - Editing Functions .....14 Section Three - Effects and Parameters ......................................17 Section Four - Other Functions .....31 Warranty We at DigiTech are very proud of our products and back up each one we sell with the following 1 Section One - Introduction Getting Acquainted Included Items About the RP1000 Preset Mode and Pedalboard Mode A Tone Library (Knob 1) Effects Library (Knob 2) Effects Level (Knob 3) 3 1. 2. 3. 4 A Guided Tour of the RP1000 Front Panel 12345678 9 1 0 1 1 1 2 13 Page Page Rear Panel 1 2 3 4 5 6 7 8 9 1 0 1 1 1 2 1 3 8 Getting Started Making Connections Amp/Cabinet Bypass Amp Loop Connection Setups Mixer Stereo Amps Amp Loop with Pre-Amp In Line Stomp Loop Amp Loop using Guitar Amps Pre Amp Amp Loop and Stomp Loop Studio Setup (Computer and Personal Monitors) 14 Applying Power Section Two - Editing Functions Preset Mode and Pedalboard Mode 15 Editing/Creating Presets 1. Select a tone with the Tone Library knob 2. Select an effect or effects chain with the Effects Library knob 3. Adjust the effects level with the Effects Level knob 16 Storing/Copying/Naming a Preset 17 Section Three - Effects and Parameters About the Effects Effect Denitions Wah Compressor Distortion Knobs 2-6 have the following functions for the various Distortions: Amplier Page EQ Noise Gate/Auto Swell Chorus/FX Knobs 2-6 have the following functions for the various Chorus types: Page Page Page Page Page Delay Reverb 31 Section Four - Other Functions Expression Pedal Footswitch Assign LFOs 32 Wah Min/Max Expression Update Factory Reset Expression Pedal Calibration 33 Preset Level Bypass Looper Page 35 Tuner USB Setup Page 37 Section Five - RP1000 Effects Descriptions Wahs Compressors Noise Gates 38 EQ Chorus Stompbox Models Flanger 39 Phasers Pitch 40 Vibrato / Rotary Tremolo 41 Envelope / Special Delays 42 Reverbs Distortions Page 44 Amps Page Page Page 48 Cabinets Page 50 Section Six - Appendix Specications 51 Tone Library Effects Library