DigiTech RP1000 owner manual Knobs 1-6 From left to right, Tone Library Knob, Effects Library Knob

8. Knobs 1-6 (From left to right)

These six knobs perform various functions, depending on which mode is currently active and what (if anything) is being edited.The functions are listed below:

Tone Library (Knob 1)

1.In Performance mode, this knob selects from a library of preset amp tones.

2.When editing a preset, this knob changes the Amp or Effect model for the selected row and pressing the knob will turn the effect row on or off. When editing an Effect row, press this knob to turn the effect on or off. When editing the Amp/Cabinet row, pressing this knob will switch between editing the amp model or the cabinet model.

3.When the Expression row is selected, this knob selects the Expression Pedal, LFO 1, and LFO 2 parameter links, footswitch 6-10 assignments,Wah pedal range, Expression Pedal update, and Stomp Loop position.

*NOTE: the assignments selected for footswitches 6-10 are only available when the Pedal- board button is active.

Effects Library (Knob 2)

1.In Performance mode, this knob selects from a library of preset effect chains.

2.When editing a preset, this knob modifies the parameter listed in the column directly above it for the selected Effect row.

3.When the Expression row is selected, this knob selects which parameter is assigned to the Expression Pedal, footswitches 6-10*, and LFO1or LFO2.

*NOTE: the assignments selected for footswitches 6-10 are only available when the Pedal- board button is active.

Effects Level (Knob 3)

1.In Performance mode, this knob adjusts the overall level of post amp model effects (Chorus/FX, Delay, and Reverb).

2.When editing a preset, this knob modifies the parameter listed in the column directly above it for the selected Effect row.

3.When the Expression row is selected, this knob selects the heel value for the pa- rameter linked to the Expression Pedal or the off state are parameters assigned to footswitches 6-10*.

*NOTE: the assignments selected for footswitches 6-10 are only available when the Pedal- board button is active.

Amp Gain (Knob 4)

1.In Performance mode, this knob adjusts the Amp Gain (distortion) for the selected Amp model.

2.When editing a preset, this knob modifies the parameter listed in the column directly above it for the selected Effect row. This knob also is used to adjust the RP/USB mix when the RP1000 is connected to a computer and using recording software. Just select the Wah row to adjust this parameter when USB is connected to the RP1000.

3.When the Expression row is selected, this knob selects the toe value for the param- eter linked to the Expression Pedal Expression Pedal or the on state are parameters assigned to footswitches 6-10*.

*NOTE: the assignments selected for footswitches 6-10 are only available when the Pedal- board button is active.

Amp Level (Knob 5)

1.In Performance mode, this knob adjusts the Amp Level (volume) of the selected Amp model.

2.When editing a preset, this knob modifies the parameter listed in the column directly above it for the selected Effect row. This knob is also used to adjust the USB Record Level when the RP1000 is connected to a computer and using recording software. Just

5