Jura Capresso S90, S95 manual Problems, Clean Unit, Unit Calced, Fault

	Cause	Action
CLEAN UNIT	You have drawn off coffee 220 times or run	Clean as described in chapter 14.6
	the rinsing program 180 times

Message still displayed, although machine cleaned

Run cleaning program again; this time do not add cleaning tablet

UNIT CALCED	The espresso/coffee machine sector needs	Run decalcifying program as described in
	decalcifying	chapter 16
	Message still displayed, although machine	Run cleaning program again; this time using water
	decalcified	only and without decalcifying agent
FAULT 2	Temperature too low	– Switch device off
		– Leave device for approx. 2 hours at room
		temperature
		– Switch device on

FAULT 8	Initialisation problem	Switch device off, disconnect from mains,
		switch on

E

20. Problems

Problem	Cause	Action
Coffee only flows in dribs	– Powder too fine	– Adjust grinder to a coarser grinding
and drabs while drawing off		– Run the rinsing programme once or twice.
		– If the problem persists, run cleaning programme
Coffee flow is stopped	– Not enough coffee powder in the system	– Draw off one cup of coffee
after pre-brewing
Grinder is extremely noisy	– Foreign element in grinder	– Proceed as described in chapter 14.5

21