Programming steam portion, Programming Filter

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

13.4 Programming steam portion

STEAM PORTION

Press key P .

PORTION /....20 SEC.

By pressing key + or - you can programme time in seconds (drawing off time of 3 – 250 sec.)

Press key P .

STEAM PORTION

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

13.5 Programming tea portion

Place a cup under the height-adjustable tea-spout (22).

Press key P .

OPEN TAP

ENOUGH TEA? / CLOSE TAP

TEA PORTION

The required portion of tea-water is programmed now.

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

13.6 Programming Filter

Please read chapter 7.1 “Placing filter“.

13.7Programming water hardness (only with setting Filter no)

HARDNESS LEVEL 3

Press key P

By pressing key + or - briefly you can programme the water hardness level.

Then press key P briefly to store the water hardness level in memory.

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

To determine the water hardness level please read chapter 6. “Adjusting for water hardness“.

13.8 Programming economy mode

ECONOMY MODE OFF

Press key P

By briefly pressing key + or - you can programme the mode you would like.

Then press key P briefly to store mode in memory

By pressing the + button, you can select the next phase, or press the N button in order to leave the programming.

You can programme your machine to “economy mode“. In the set- ting ECONOMY MODE ON the steam heating-system is switched off. The heating for the cup warming tray is switched off too. If you want to draw off steam you need to press the steam key , warning lamps flash and your machine heats up.

After 10 minutes the steam heating-system switches off automatically. The warning lamps go out. By pressing the steam key anew, you return to stand-by-status for drawing off steam.