11.7 Insert filter
Pull up the cartridge holder in the water tank. Pressing gently, put the filter cartridge into the water tank (Fig. 4).
Close the cartridge holder until it engages audibly.
Fill the water tank with cold fresh tap water and put it back into the machine.
Switch the machine off with the ON/OFF 
switch.
Press the 
Press the 
symbol is still alight.
Press the ON/OFF 
switch as a confirmation. The 
, 
symbols light up.
Place a sufficiently large vessel under the pivoting nozzle for hot water/steam (13) and turn the selector switch for hot water/ steam (12) to the position 
.
Draw off water until the 
symbol lights up.
Now turn the selector switch for hot water/steam (12) back to the position 
.
When the 
symbol lights up, press the maintenance key (4). Your machine rinses and is ready for drawing off coffee.
The water can be slightly discoloured (not dangerous to health)
11.8 Replace filter
After 50 litres have been drawn off, the filter loses its effect. The 
symbol flashes to inform you.
If you do not draw off often, you should replace the filter cartridge every 2 months, but no report appears on the dis- play. There is a special disk on the cartridge holder so that you can set the replacement date.
Switch your machine off with the ON/OFF 
switch.
Press the maintenance key (4) for about 3 seconds. The 
, 
symbols light up.
Empty the water tank and lift up the cartridge mounting. Pressing gently, put the new filter cartridge into the water tank (Fig. 4)
Place a sufficiently large vessel under the pivoting nozzle for hot/water steam (13) and turn the selector switch for hot water/steam (12) to the position 
. The 
symbol flashes.
Draw off water until the 
symbol lights up.
Now turn the selector switch for hot water/steam (12) back to the position 
.
When the 
symbol lights up, press the maintenance key (4). Your machine rinses and is ready for drawing off coffee.
11.9 General cleaning instructions |
| |
E | ||
Never use abrasive articles or corrosive chemicals to clean your | ||
machine. |
|
Wipe down the casing on the inside and out using a soft, damp cloth.
Clean the pivoting nozzle for hot water/steam after each use.
After heating milk, draw off a little hot water in order to clean the inside of the pivoting nozzle.
You can take off the frothing aid for a thorough cleaning (Fig. 8).
The water tank should be rinsed out and filled with clean water every day.
If there is scale visible in the water tank, you can remove it with a customary
13