Jura Capresso E40, E60, E65, E45 manual Descalcifying

13. Descalcifying

The machine has an integrated de-scaling programme. If you use a Claris filter cartridge, your machine does not need de-scaling. Only use Jura cleaning tablets. They are available from your Jura dealer.

If the machine needs de-scaling, the symbol flashes.

You can continue to draw off coffee and hot water/steam and then run the de-scaling programme later.

Only run the de-scaling programme when the machine has been switched off for at least 2 hours and has cooled down well. The de-scaling programme is started with the machine switched off. Once it has started, the de-scaling programme must not be interrupted.

Switch your machine off with the ON/OFF switch and leave it to cool down for 2 hours.

Remove the water tank and empty it.

Press the maintenance key (4) for about 3 seconds. The , symbols light up.

Empty the drip tray and the grounds container and put both of

them back in again. The symbol goes off and the , symbols light up.

Completely dissolve the contents of one blister (2 tablets) in 0.5 litres of water in a vessel and pour the mixture into the water tank. Put the tank back in again. The symbol appear.

Turn the selector switch for hot water/steam (12) to the position

. The symbol go off and the , symbols light up.

Place a sufficiently large vessel under the pivoting nozzle for hot water/steam (13) and press the maintenance key (4).

The lighting of the symbol and the flashing of the symbol show you that the de-scaling process has been activated.

If the symbol lights up, empty the drip tray (if necessary) and put it back in again. The symbol lights up.

Turn the selector switch for hot water/steam (12) back to the position .

The de-scaling process is continued de-scaling solution is guided into the drip tray in the interior of the machine.

The , , symbols light up.

Rinse the water tank out well and fill it with cold fresh tap water. Then put it back into the machine again. Place a sufficiently large vessel under the pivoting nozzle.

Empty the drip tray and put it back in again. The , symbols light up.

Turn the selector switch for hot water/steam (12) to position .

 Place a sufficiently large vessel under the pivoting nozzle for hot		E
water/steam (13) and press the maintenance key (4).
The lighting of the symbol and flashing of the	symbol show
you that the de-scaling process has been activated.

If the , , symbols light up, empty the drip tray (if neces- sary) and put it back in again.

Turn the selector switch for hot water/steam (12) back to the position .

The de-scaling process is continued and the water is guided into the drip tray in the interior of the machine.

If the symbol lights up, empty the drip tray and put it back in

again. The symbol appear.

After this, press the maintenance key (4). Your machine rinses and is now ready for the next draw-off of coffee.

15