PROPER INSTALLATION AND LOCATION
LOCATION
•The water dispenser should be installed in an environment where the temperature ranges between 10ºC and 38ºC. Relative humidity should not be higher than 90%
•Avoid direct sunshine
•The rear of the water dispenser should be at least 10 inches / 25 centimeters from the wall to allow for proper air circulation
•Never place the water dispenser on paper or foam, possibly causing an unstable condition
•Do not place anything flammable besides the water dispenser
TIPS
•If the dispenser is not going to be used for an extended period of time, turn the water dispenser OFF, unplug the power cord and drain the remaining water
PRIOR TO FIRST TIME USE
•In case the hot or cold water is not needed for an extended period of time, turn the appropriate function OFF (Cooling or heating) in order to save electricity
WARNING: The dispenser should not be turned on until at least 3 minutes have gone by since it was turned off.
IMPORTANT: Prior to using the Water Dispenser for the first time, the water tanks need to be flushed in order to prevent the water from tasting awkward.
The water dispenser tanks also need to be cleaned periodically to prevent buildup of mineral deposits that can affect water taste and flow. To clean the water tanks:
1.Make sure that the water dispenser is OFF
2.Mix one quart of water with either one quart of vinegar or four ounces of citric acid crystals
3.Pour the solution in the opening at the top of the dispenser
4.Press each dispenser button until water just begins to flow from the tap
5.After about twenty minutes, press the dispenser buttons until no more water comes out of the taps and drain the hot water tank (see Draining the Dispenser, page 7).
6.Reinstall the water bottle ( see Loading the Dispenser, page 5)
IMPORTANT: Before use, dispense one quart of water from each tap to make sure the cleaning solution is completely removed.
Electronic Controls & Display Overview
5