Sylvania SE80092 Cleaning and Caring for the Dispenser, Cleaning the Dispenser Cabinet

Page 8

CLEANING AND CARING FOR THE DISPENSER

IMPORTANT: Turn the water dispenser off and unplug it before cleaning

Cleaning the Dispenser Cabinet

The dispenser cabinet can be washed with mild soap and Never use commercial cleaners or abrasive powders. water. Rinse thoroughly with clear water.

Cleaning the Condenser

Sweep away or vacuum up dust from the condenser coils specially designed for this purpose. These are usually

on the back of the unit. For best results, use a brush

available at most appliance stores.

 

.

 

 

 

Cleaning the Drip Tray and Grille

 

 

The dispenser drip tray is not self-draining. To reduce

Water left in the tray may leave deposits. Remove the

 

water spotting, the tray and its grille should be emptied,

deposits by adding undiluted vinegar to the tray. Soak until

 

cleaned and wiped dry regularly.

the deposits disappear or become loose enough to rinse

 

 

 

 

away.

 

Cleaning the Water Tanks

 

 

The water dispenser tanks need to be cleaned periodically

7 After about twenty minutes, press the dispenser

 

to prevent buildup of mineral deposits that can affect water

buttons until no more water comes out of the taps

 

taste and flow. To clean the water tanks:

and drain the hot water tank (see Draining the

 

1

Remove the water bottle

Dispenser, page 7).

 

2

Drain the water tanks ( see Draining the Dispenser,

8 Reinstall the water bottle ( see Loading the

 

 

 

page 7)

Dispenser, page 5)

 

3

Set both power switches to the OFF position

IMPORTANT: Before use, dispense one quart of water

 

4

Mix one quart of water with either one quart of

from each tap to make sure the cleaning solution is

 

 

 

vinegar or four ounces of citric acid crystals

completely removed.

 

5

Pour the solution in the opening at the top of the

 

 

 

 

dispenser

 

 

6

Press each dispenser button until water just begins

 

 

 

 

to flow from the tap

 

 

 

 

 

 

 

Draining the Dispenser

The dispenser should be drained before cleaning the tanks and for extended periods of non-use.

1.Remove the water bottle from the dispenser.

2.Press both dispenser buttons until no more water comes out of the taps.

3.Place a bucket beneath the drain plug. The drain plug is located at the rear of the dispenser (see image to the right).

4.Remove the cap from the drain plug and allow water to drain completely. Replace the cap.

IMPORTANT: Turn the water dispenser OFF and unplug it before draining. Allow the dispenser to cool overnight before draining to reduce the risk of scalding

Drain plug cap

8

Image 8
Contents Hot & Cold Water Dispenser Table of Contents Safety Instruction Safety Precautions Grounding InstructionsProper Disposal of the Water Dispenser Parts OverviewProper Installation and Location Prior to First Time USESetting UP the Water Dispenser SETSpecifications Using the Water DispenserUsing the Refrigerated Compartment Cleaning and Caring for the Dispenser Cleaning the Dispenser CabinetTroubleshooting Tips Problem Possible CausesSonigem Service Guide d’utilisation Table DES Matières Mesures DE Sécurité Instructions DE Mise À LA MasseÉlimination adéquate du distributeur Nomenclature DES PiècesInstallation Dans UN Endroit Adéquat Avant L’UTILISATION InitialeContrôles Électroniques ET Affichage Réglage DU Distributeur Utilisation DU Distributeur D’EAU Utilisation DU Compartiment RéfrigéréSpécifications Entretien ET NettoyageVider LE Distributeur Guide de dépannage Sonigem