Green
Yellow
1
2
3
ENGLISH 43
When the water tank is empty, remove the water tank, rinse it and fill it up to the MAX level with fresh water. Place it back into the machine.
Empty the container back and place it back under both the steam/hot water wand and the dispensing spout.
When the amount of water needed for the rinse cycle has been com-
pletely dispensed, this icon on the side is displayed. Press the “” button to quit the descaling cycle.
Press the “” button to prime the circuit.
The machine now carries out the
Remove and empty the container.
Empty the drip tray and place it back.
The descaling cycle is now complete.
Remove the small white filter and replace the INTENZA+ water filter (if fitted) in the water tank. Reinsert the Classic Milk Frother.
Note:
At the end of the descaling cycle, wash the brew group as described in the “Weekly cleaning of the brew group” chapter.
The two rinse cycles are performed in order to have the circuit cleaned with a preset amount of water to ensure proper machine performance. If the water tank is not filled up to MAX level, the machine might require three or more cycles.