PSB Speakers G5C 0250 SET-UP Positioning, Installation, Filling The Thermal Mass Reservoir

Page 4

PSB INDUSTRIES INC. • General Air Division • 1202 West 12th Street, Erie, PA. 16501

G5C Dryers

Phone : 814-45—3651 Fax : 814-454-3492 • www.PSBINDUSTRIES.com • psb@genair.net

 

3.0SET-UP

3.1Positioning

The dryer should be located in an area with a flat floor and protection against weather conditions and, if possible, direct sun light. The area must also be properly ventilated (& heated, if necessary) so that the temperature is kept between 40 °F and 110 °F when the dryer is running (remember that the operating dryer will add heat to the room). It must also be large enough to allow at least three feet of free space adjacent to both the condenser air inlet and outlet grills to allow for proper unit cooling.

3.2Installation

•Air by-pass piping is recommended to allow uninterrupted air service during instances of maintenance of repair.

•Prior to installation check to insure that the compressed air piping is free of debris or other contaminants.

•Connect the dryer to the compressed air line in accordance with one of the diagrams shown in section 11 and per unit labeling.

•Always use a back-up wrench to prevent damage to the connections during piping of the air inlet and outlet.

•Make sure that line power agrees with the unit data plate and the service complies with local electrical codes.

•Always include a fused safety switch in the line power supply (refer to data plate amperage for proper selection).

•A particulate filter is recommended at the air inlet to avoid any deposit of solid particles into the dryer.

•Position the dryer so that all controls can be easily read and so that all maintenance operations are easily performed.

•Connect the condensate drain tube in compliance with local regulations. The condensate is a pollutant and cannot be drained directly into the sewage system. A Motivair oil/water separator of suitable capacity is recommended.

3.3Filling The Thermal Mass Reservoir

•Remove the threaded plug (A) from the fill port located on the top panel of the dryer.

•Slowly fill the reservoir with clean, tap water until it can be seen coming from the flexible overflow tube (B) at the rear of the dryer.

•Replace the fill port plug.

3.4 Start-Up

•Close inlet and outlet valves, switch on S1 and ON/OFF (hold for 3 seconds), and check for the pilot light on the control panel.

•Allow the dryer to run until the word “ICE” appears in the digital display (usually about 15 minutes).

•Open the outlet air valve completely and then gradually pressurize the dryer by slowly opening the inlet air valve.

•Compressed air flow rates in excess of rating will reduce performance but will not compromise safety.

4/16

Cod. 710.062.01.00 – Rev.08 – 02.05.02

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Glacier General Always Machine Unpacking and HandlingInstallation SET-UP PositioningFilling The Thermal Mass Reservoir Start-UpMaintenance Equipment DataG5C Dryers Control Panel Operation Status LEDsButton Functions Set Point ModificationTroubleshooting Digital DisplayPhone Maintenance 10/16ZERO-LOSS Drain Trap OperationDimensional Data 11/16Refrigeration Circuit Diagrams Electrical Wiring Diagrams12/16 G5C 18 Thru 75 115/1/60 Cod13/16 G5C 115/1/60 Cod14/16 15/16 G5C 250 460/3/60 Control Wiring Diagram G5C 250 460/3/60 Power Wiring DiagramCod .003.02.00 Rev 17/16 System Installation & Layout Diagram G5C 250 460/3/60 Parts List Cod .003.02.00 Rev18/16

G5C 0018, G5C 0250 specifications

The PSB Speakers G5C 0250 and G5C 0018 are designed to elevate your audio experience, combining innovative technologies with high-quality craftsmanship. These speakers embody the brand's commitment to delivering rich, detailed sound that brings music, movies, and games to life.

The G5C 0250 features a proprietary driver configuration that ensures a wide soundstage and exceptional clarity. It is equipped with a 5.25-inch polypropylene woofer and a 1-inch titanium dome tweeter, offering balanced playback across a broad frequency range. This speaker excels in delivering deep bass and crisp highs, making it ideal for both music enthusiasts and home theater setups. The compact design allows it to fit seamlessly into any room without sacrificing sound quality, making it a versatile option for various listening environments.

On the other hand, the G5C 0018 is a powerful option for those seeking an immersive audio experience. It boasts a dual 6.5-inch woofer system combined with a 1-inch aluminum dome tweeter. This combination permits it to produce rich bass and detailed treble, ensuring that every note of your favorite tracks is reproduced accurately. The G5C 0018 also features PSB's unique Bass Reflex design, which enhances bass performance while minimizing distortion, creating a more enjoyable listening experience.

Both models incorporate advanced technologies such as computer-optimized crossover networks that ensure smooth frequency transitions between drivers. This results in a coherent sound signature that is both natural and engaging, regardless of the genre being played. Additionally, the cabinets are constructed from high-quality MDF, reducing unwanted vibrations and resonances for clearer sound reproduction.

In terms of aesthetics, the G5C 0250 and G5C 0018 sport elegant finishes that allow them to blend seamlessly into any decor. They are available in multiple color options, providing flexibility for different interior styles.

Overall, the PSB Speakers G5C 0250 and G5C 0018 stand out as exceptional choices for anyone looking to enhance their audio experience. With their combination of advanced technologies, premium build quality, and beautiful design, these speakers deliver a performance that is sure to satisfy even the most discerning audiophiles.
Top Page Image Contents