Quadra-Fire 7068-112 Listing and Code Approvals, Appliance Certification, Glass Specifications

Page 6

R

Castile & Santa Fe CE Pellet Stove

1 Listing and Code Approvals

A. Appliance Certification

Model

Santa Fe or Castile Pellet Appliance

Type

Residential Space heating appliance fired

 

by wood pellets

Standard

EN 14785:2006

 

 

 

 

 

 

 

 

Hearth & Home Technologies

1445 North Highway

Colville, WA 99114

United States

2011

B. Glass Specifications

D. Specifications

Distance to Adjacent Com-

Standoff to Rear: 50mm

bustion Materials:

Standoff to Side: 160mm

CO Concentration at 13%

Max: 0.003

 

Min: 0.030

 

 

Flue Gas Temperature:

161oC

*Thermal Output:

Max: 6.3 kW

 

Min: 3.0 kW

Energy Efficiency:

Max: 75.1%

 

Min: 75.0%

Heating Capacity:

220m2 to 350m2

Hopper Capacity:

18 kg

Fuels:

Wood Pellets, less than

 

38mm in length, 6mm to

 

8mm in diameter

Shipping Weight:

109 kg, add 18 kg when

 

the hopper is full

This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

C. Electrical Rating

230 VAC, 50 Hz, Start 2.80 Amps, Run 0.80 Amps

NOTE: Some generator or battery back-up systems may not be compatable with the micro-processor elec- tronics on this appliance. Please consult the power supply manufacturer for compatable systems.

NOTICE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its prod- ucts, their specifications and/or price without notice.

*Thermal output will vary, depending on the type of fuel you use in your appliance. Consult your Quadra-Fire dealer for best results.

WARNING! Risk of Fire! Hearth & Home Technologies dis- claims any responsibility for, and the warranty and agency listing will be voided by the above actions.

DO NOT:

Install or operate damaged appliance

Modify appliance

Use as an incinerator or any other different way from which it was conceived

Install other than as instructed by Hearth & Home Technologies

Operate the appliance without fully assembling all components

Overfire

Install any component not approved by Hearth & Home Technologies

Install parts or components not Listed or approved.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualified installer, service agency or your dealer.

Quadra-Fire is a registered trademark of Hearth & Home Technologies

Page 6

7068-112

August 19, 2011

Image 6
Contents Models Hot glass will cause burnsCastile & Santa Fe CE Pellet Stove Santa FE CE Pellet StoveTable of Contents Castile & Santa Fe CE Pellet Stove Castile & Santa Fe CE Pellet Stove Appliance Certification Glass SpecificationsListing and Code Approvals Electrical RatingUser’s Guide Operating InstructionsCastile & Santa Fe CE Pellet Stove Fire Safety Combustible/Non-Combustible MaterialsFuel Material and Fuel Storage Starting Your First Fire Before Your First FireFilling the Hopper with Fuel Thermostat Calls For HeatIginition Cycles Fire CharacteristicsFeed Rate Adjustment Instructions Clear SpaceTypes of Fuel Quick Reference Maintenance ChartMaintaining & Servicing Your Appliance Frequency Daily Weekly Monthly YearlyCleaning Beneath Heat Exchanger Cleaning Firepot with Cleaning Rod & Firepot Clean-Out ToolCleaning Ash Pan/Drawer Ash Removal from FireboxCleaning the Hopper Cleaning Heat Exchanger Chambers & Drop TubeCleaning the Exhaust Path Door Latch InspectionTask Contact your local dealer Cleaning the Top Vent Adapter Preparing Firebox for Non-Burn SeasonIncorrect Tall, Lazy Flame, Orange in Color Troubleshooting for Homeowner Frequently Asked QuestionsAppliance Location Design, Installation & Location ConsiderationsGetting Started Floor SupportPre-Burn Check List Castile & Santa Fe CE Pellet Stove Thermostat LocationTools And Supplies Needed Inspect Appliance and ComponentsDimensions and Clearances Appliance DimensionsVertical Installation Alcove InstallationCorner Installation Straight Back Against WallException for Horizontal Installations Castile & Santa Fe CE Pellet Stove Hearth Pad RequirementsRecommended Hearth Pad Requirements Venting Termination Requirements Negative Pressure, Shut-Down and Electrical Power FailureVent Information Avoiding Smoke and OdorsDraft Vent ConfigurationsNegative Pressure Minimum Vacuum Requirements 0957068-112 August 19 Castile & Santa Fe CE Pellet Stove Pellet Venting Charts Miniumum Vertical Vent for Two ElbowsVenting Systems AlcoveVertical into Existing Chimney Air Clearance to PipeConcrete Cap MasonryAlternate Masonry With AirspaceStraight Out DegreeCastile & Santa Fe CE Pellet Stove Through The Wall Appliance Set-Up Outside Air Kit Instructions Shown on Santa FEThermostat Installation Two Piece Log Set InstallationContact Information

7068-112 specifications

The Quadra-Fire 7068-112 is a high-performance gas-burning fireplace designed to bring warmth and elegance to any home. With its sleek design and advanced technology, it stands out as a preferred choice for homeowners looking for both form and function.

One of the main features of the 7068-112 is its impressive heating capacity. It can efficiently heat spaces up to 2,000 square feet, making it an excellent option for larger rooms or open-concept living areas. The unit boasts an impressive thermal efficiency rating, ensuring that consumers can enjoy a cozy fire without wasting energy.

The fireplace is equipped with a variety of user-friendly controls, allowing homeowners to easily adjust the flame and heat settings to achieve their desired ambiance. It features an adjustable flame height, allowing for customization of the fire's intensity, and a remote control option for added convenience. With these controls, users can effortlessly create a comfortable atmosphere from across the room.

Another notable characteristic of the Quadra-Fire 7068-112 is its unique combustion system. The fireplace utilizes a patented technology known as the Quadra-Fire Design, which promotes efficient heat delivery and emissions control. This system ensures that gases are burned thoroughly, resulting in reduced smoke and harmful emissions. In addition, the unit is equipped with a primary air control that helps maintain optimal burning temperatures, further enhancing efficiency.

The decorative options are also impressive with the 7068-112. It features a beautiful glass front that showcases the mesmerizing flames while offering a modern look. Homeowners can choose from an array of decorative media such as river rocks or glass beads to customize the appearance of their fireplace and complement their home decor.

In terms of installation, the 7068-112 is versatile, featuring a direct vent system that allows for flexible placement in a home. This venting method ensures that fresh air is drawn from the outside while safely venting exhaust gases outdoors, making it suitable for a variety of settings.

Overall, the Quadra-Fire 7068-112 is a stylish, efficient, and customizable heating solution that combines advanced technology with beautiful design, making it a desirable addition to any home.