Replacing Interior Halogen Lights Analog Models

Replacing Interior Halogen Lights (Analog Models)

Do not touch bulb with bare hands. Clean any signs of oil off of the bulb and handle with a soft cloth.

Service Information

If your oven should fail to operate:

1.Is the electrical cord securely inserted into the electrical outlet?

2.Is the circuit breaker open, or is fuse blown?

1.Unsnap glass light cover at opposite end from metal hinge.

2.Firmly grasp light bulb and pull out.

3.Replace with a 64405, 12V-5W bulb.

4.Replace the light cover by first sliding into metal hinge and then snapping close on opposite end.

5.Reconnect power at the main fuse or circuit breaker.

Metal hinge

Glass light cover

Light bulb

If service is required:

1.Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area.

2.Have the following information readily available:

a.Model number

b.Serial number

c.Date of purchase

d.Name of dealer from whom purchased

3.Clearly describe the problem that you are having.

Power Failure

Do not attempt to use during a power failure. Unit will not function.

TROUBLE SHOOTING GUIDE

Problem		Possible Cause and/or Remedy
1.	Oven will not function	Oven is not connected to electrical
		power. Have electrician check power
		circuit breaker, wiring and fuses.
2.	Oven does not	Door is not shut tight enough for
	operate in self-clean	automatic door latch to lock.
3.	Oven is not clean	Temperature control knob not rotated all
	after self-clean cycle	the way pass cletent until it stops.
4.	Broil does not	Temperature control knob is rotated too
	work	far past broil position.
5.	Door will not open	Oven is still in self-clean mode. If oven is
		hot, door latch will release when a safe
		temperature is reached.
6.	Oven light will not work	Light bulb is burned out
		Oven is not connected to power.
		38

If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking Range Corporation at (662) 451-4133 or write to:

VIKING RANGE CORPORATION

PREFERRED SERVICE

111 Front Street

Greenwood, Mississippi (MS) 38930 USA

Record the following information indicated below. You will need it if service is ever required. The serial number and model number for your oven is located on the identification plate mounted on the bottom left side of the oven door opening.


Model Number						Serial Number
Date of Purchase						Date Installed
Dealer's Name

Address

If service requires installation of parts, use only authorized parts to ensure protection under the warranty.

This manual should remain with the oven for future reference.