i n t e l l i g e n t | w i r e l e s s | p l a t f o r m |
|
|
|
2.8. aCNPT Router/NAT Configuration
The aCNPT unit can also be configured in Router or NAT mode which behaves like Infrastructure mode. The procedures for configuring the parameters in Router/NAT mode are given below. In this mode, the units will associate with any access point.
Note: The configuration procedure of parameters in NAT mode is the same as for Router mode.
2.8.1. Ethernet Configuration
The Ethernet IP is configured during the operational mode change to aCNPT Router mode.
Follow these steps below if you need to
1.From the ’Summary Information’ page, click on the ’Ethernet Configuration’ link to change Ethernet parameters.
2.Enter the ‘IP address’ and ‘IP mask’.
3.Click on ‘Apply Changes’ to effect the changes.
Figure 2-15 aCNPT Router Ethernet Configuration
airClient™ Nexus PRO TOTAL User Guide | Page 28 of 78 |
|