i n t e l l i g e n t | w i r e l e s s | p l a t f o r m |
|
|
|
2.8.4. DHCP Relay Configurations
If the user has a DHCP Server, the aCNPT Router can be configured as a DHCP Relay agent of the DHCP Server for IP address assignment.
Follow the steps below to configure the aCNPT Router unit as a DHCP Relay Agent:
1.Click on ‘Networking’ ‘DHCP Server’ from the drop down menu to access the DHCP Configuration page.
Click on ‘Enable DHCP Relay’ to choose DHCP Relay mode.
3.Enter a valid DHCP Server IP.
4.Click on the ’Apply Changes’ to start the DHCP relay agent.
Note: The system will validate the input parameters and notify users of invalid entries.
The DHCP Server IP will be in the same network segment as the device wireless Radio IP address.
The DHCP Server needs to be configured to serve IP range of the wired side Ethernet IP.
The DHCP Relay Agent is only available to hosts connected to the same LAN segment as the device
Figure 2-22 DHCP Relay Agent Configurations
airClient™ Nexus PRO TOTAL User Guide | Page 33 of 78 |
|