Kenmore 790.46268 manual Genera Care & C eaning contd, To Raise theTop for C eaning

Page 16
To Raise theTop for C_eaning

Genera Care & C eaning (cont'd)

To Raise theTop for C_eaning

1.Grasp the sides and lift from the front. A lift-up rod wiii support the top in its raised position. Only lift the top high enough to allow the support rod to rest in place under the front of the cooktop.

2.Clean underneath using a clean cloth and hot, soapy water.

3.To lower the top, lift the top slightly and lower the rod. Lower the range top down into the range frame.

A rod swings up to support

_

When lowering the lift-up range top, grasp the sides with fingertips only. Be

 

careful not to pinch fingers. DO NOT drop or bend the range top when raising or lowering. This

neath,

could damage

the surface.

Care and C_eaning of Stainless Stee_ (Stainless Steel models only)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the

appearance of stainless parts. Please refer to the table provided at the beginning of the General Care & Cleaning section in this Use & Care Guide.

Hinge support

Lock engaged for door remova! Figure 1

HINGE SLOT - Door removed

from the oven Figure 2

Hinge lever

Removing and Replacing the Oven Door

The door is heavy. For safe, temporary storage, lay the door fiat with the inside of the door facing down.

To Remove Oven Door:

1, Open the door to the fully opened position,

2.Pull up the lock located on both hinge supports and engage it in the hinge lever hooks (Figure 1). You may have to apply a little downward pressure on the door to pull the locks fully over the hinge lever hooks.

3.Grab the door by the sides and pull the bottom of the door up and toward you to disengage the hinge supports. Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disen- gage the hinge levers (Figure 2).

4.To clean oven door, follow the instructions provided in the Genera! Care & Cteaning table.

To Reptace Oven Door:

1.Grab the door by the sides; place the hinge supports in the hinge slots. Open the door to the fully opened position.

2.Disengage the lock from the hinge lever hooks on both sides (Figure 3). Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.

3.Close the oven door.

Specia_ Door Care mnstruetions - Most oven doors contain glass that can break.

Read the following recommendations:

1.Do not close the oven door until all the oven racks are fully in place.

2.Do not hit the glass with pots, pans, or any other object.

3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

Lock in normal position Figure 3

16

Image 16
Contents Models, Modelos Slide-inmodels Modelos deslizablesElectric Contents Kenmore Appliance WarrantyProduct Record Seria P ate LocationInstall injurymMPORTANT mNSTRUCTmONS FOR USING YOUR COOKTOP MPORTANT mNSTRUCTmONS FOR USING YOUR OVENFOR COOKTOPSWmTH COIL ELEMENTS ONLY FOR GLASS COOKTOPS ONLYSELF-CLEANmNGOVENS mMPORTANT mNSTRUCTmONS FOR CLEAN raNGYOUR RANGEmMPORTANT SAFETY NOTmCE PROTECTION AGREEMENTS In the U.S.AElectronicOvenControlsSurfaceElement Setting Surface Controls Selecting Surface Cooking CookwareCookware Material types CorrectIncorrectBefore Setting Oven Controls Setting Oven ControRs Oven Controm FunctionsTo Set the C ock To Set the MinuteTirnerSetting Oven ControRs contd Setting Oven Controls contd Oven Baking hformationSetting Oven Controls contdTo Broil Broiling TipsCleaning Various Parts of Your Range GeneraR Care & C eanin9Decorative Trim Pieces Genera Care & C eaning contd Porcelain Ename Cooktop Cleaning mnstructionsTo Raise theTop for C eaning Removing and Replacing the Oven DoorPorcelain Ename Oven C eaning GeneraR Care & C eaning contd StorageDrawer Removing and ReplacingOCCURRENCE Before you callPOSSBLE CAUSE/SOLUTmON Before calliii ii!!!!!ii Notesiiiiiiii!iii Your Home Our Homet 18008276655