Kenmore 790.7943 manual Setting Oven Controls, Instructions Press Display

Setting Oven Controls

Setting the Clock

Changing between 12 or 24 hour display

Silent Control Operation

Setting the Clock

The CLOCK _ pad is used to set the clock. The clock may be

set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is

first plugged in, or when the power supply to the range has been interrupted, the dock in the display will flash (See Fig. 1).

Fig. 1

INSTRUCTIONS PRESS DISPLAY

To set the clock (example below for 1:30):

1. Press		. "CLO" will appear in the display		(See	Fig. 2).
					Fig. 2
,	Press		pads to set the time	of day to 1:30
	(See	Fig. 3). Press _"_.	"CLO" will disappear	and	the clock
	will start (See Fig. 4).				Fig. 3

Changing between 12 or 24 hour time of day display:

1. Press and hold _	for 6 seconds untill "12h" or "24h"	6 seconds
V	(_for
appears in the display.

2.Press _cc_x,'to switch between the 12 and 24 hour time of day display. "12h" or "24h" will be displayed (See Figs. 5 or 6).

3.	Press	(_	to accept	the desired	change or press O		to
	reject the change.				in To set the
4.	Reset the correct time as described					clock	above.
	Please note that if the 24 hour time of day mode was chosen,
	the clock will now display time from				00:00 through	23:59	hours.	Fig. 6
Setting		Silent	Control	Operation
The DELAY START _and				FLEX CLEAN _		pads control the Silent Control operation		feature. The Silent Control

operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.

INSTRUCTIONS PRESS DISPLAY

To change control from normal sound to silent control operation:

1.To tell if your range is set for normal or silent operation press

and hold d_for6 seconds. (See Fig. 7) _for 6 seconds Fig. 7

2.Press _c_a_ to switch between normal sound operation and

silent operation mode. The display will show either "SP" (See Fig. 8) or" =="(See Figs. 2 or 3).

Fig. 8

If "SP" appears (See Fig. 2), the control will operate with normal sounds and beeps. If" ==" appears (See Fig. 9), the control is set for silent operation mode.

3. Press @	to accept the change or press Q to reject the	@orQ	Fig. 9
change.

13