Kenmore 3232, 790.323, 3233, 3231, 3235 Dual Ring Burner Head Assembly, Bridge Burner Head Assembly

Before	Setting Surface	Controls
Burner	Cap	Assembly		of	the simmer,		regular,			power and turbo boil
		surface burner caps and burner grates
		It is very important to make sure that all of the Surface Burner Caps
		and Surface Burner Grates are installed correctly and at the correct
		locations.
		1.	Remove	aii	packing	material	from		cooktop		area.
		2.	Discard	all	packing	material	(if	applicable).
		3.	Position	the	burner	caps in the		correct		position.
		4.	Unpack	Burner Grates and			position		on the		cooktop.

Fixed Burner Head

Note: Burner heads are fixed. Do not try to remove them.

REMEMBER m DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS

\	•Gas Opening	OR ANY	OTHER	MATERIAL TO ENTER THE GAS OPENING.	Always
		keep the	Burner	Caps in place whenever the surface burners	are in use.

Burner Caps

Figure 1

Dual Ring Burner Head Assembly

Maize sure that the Burner Caps and Burner Grates are installed properly and at the correct locations.

1. Remove aii packing tape from cooktop and the dual burner.

2. Discard aii packing material located under aii Burners (if applicable).

Fixed Burner Head

3.To install Burner Caps, refer to figure 2 and maize sure both caps are aligned properly with the burner head.

4.Put back the grates on the cooktop.

REMEMBER -- DO NOT ALLOW SPILLS,FOOD, CLEANING AGENTS

OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER

OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use.

Bridge

Burner

End

Cap

Bridge Burner

Center

Cap

Bridge Burner

End

Bridge Burner Head

I

igniter Hole

igniter

Figure 2

Bridge Burner Head Assembly

Maize sure that the Burner Caps and Burner Grates are installed properly and at the correct locations.

1.Remove aii packing tape from cooktop and the bridge burner.

2.Discard aii packing material located under all Burners (if applicable).

3.Install Burner Caps, these include one Bridge Burner Center Cap (rectangular shaped) and the two Bridge Burner End Caps (The Bridge Burner End Caps will fit either the front or rear Bridge Burner Head locations). Maize sure that the tabs located under the Bridge Burner Caps fail into the slots located

in the Bridge Burner Head (See arrows in Figure 3) and that aii the Bridge Burner Caps lie fiat and evenly on the Bridge Burner Head.

4.Put back the grates on the cooktop.

NOTE: The Bridge Burner Head is removable but should left in place. If you need to put it back in place, take caution not to damage the igniters. Also make sure the Bridge Burner Head is fiat on the cooktop.

Cap

Hole

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!!!!!!ii!!!iiilREMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR

ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.

Figure 3	Always	keep the Burner Caps and Burner Heads in place whenever the
	surface	burners are in use.