Kenmore 3233, 790.323, 3232, 3231, 3235 Setting the Dual Ring Burner, Simmering Operation Zone a

Page 11

Setting Surface Burner Controls

Setting the Dual Ring Burner

The Dual Ring Burner has two rings of flame that you can control for two different heat levels, one for small and one for large cookware.

Large Caokware Operation (Figure 1; Zone A & B)

1.Place a large cooking utensil centered over the dual surface Burner Grate.

2.Push the surface control knob down and turn counterclockwise out of the OFF position.

3.Release the knob and rotate to the LITE position (Figures 2 & 3). Note: All electronic surface ignitors will spark at the same time. However, only the selected surface Burner will lite.

4.Visually check that the burner has llt.

5.When the burner is lit, continue to turn the control knob counterclockwise between the HI position and the MED position to adjust to the desired flame size for both burners together (figure 1). DO NOT cook with any of the surface control knobs in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position).

Simmering Operation (Figure 1; Zone A)

1.Place a small cooking utensil centered over the dual surface Burner Grate.

2.Push the surface control knob in and turn counterclockwise out of the OFF position (See Figures 2 & 3).

3.Release the knob and rotate to the LITF position. Note: All electronic surface ignitors will spark at the same time. However, only the Dual Burner will ignite.

4.Visually check that zone A & B of dual burner has llt.

5.Continue to turn the gas control knob counterclockwise past the MED position; zone B will turn off. Adjust the simmer flame size by turning the control knob between the MED position to the LO position. DO NOT cook with the surface control knob in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position).

LITE

Figure 3

Figure

Figure 2

Figure 4

11

Image 11
Contents Ie Elite Contents MWHAT to do iF YOU Smell GAS This symbol ThatProper Installation--Be sure your appllance is properly Instructions givenDo Not Use Decorative Surface Burner Covers. If a IMPORTANT Safety NoticePlease carefully read and save these instructions Serial plate is Located under the J burner box Product RecordConversion to Liquefied Petroleum Gas or L.P. Gas Control Locations of the Gas Surface Burners Before Setting Surface ControlsRemember m do not Allow SPILLS, FOOD, Cleaning Agents Dual Ring Burner Head AssemblyBridge Burner Head Assembly Use Proper Cookware Using a wok .or suppliedSurface Cooking Manual Lighflng Setting Proper Surface Burner Flame SizeSeffing Surface Burner Controls Such as salt and pepper shakers, spoonOperating the Bridge Burner Setting the Bridge BurnerSeffing the Bridge Burner Simmering Operation Zone a Setting the Dual Ring BurnerPorcelain enamel cooktop cleaning instructions some models General Care & CleaningCleaning Various Parts of Your Cooktop Heads Cleaning the gratesCleaning the burner caps CleaningSurface burner flame is orange Solutions to Common ProblemsBefore You Call Surface burner flame burns half wayMaster Protection Agreements Protection AgreementsCall anytime, day or night U.S.A. and Canada Your Home