Cooktop Control Pads
Using the Touch Control
Be sure that your finger is placed in the center of the touch pad. If the finger is not placed on the center of a pad, the cooktop may not respond to the selection made.
Lightly contact the pad with the fiat part of your entire
fingertip. Do not just use the narrow end of your fingertip.
Fig. 10
Cooktop Power Pad
The Cooktop POWER key pad activates the entire Cooktop. To power the cooktop, touch and hold the POWER key pad for 2 seconds. A beep will sound and the Power LED will glow (Fig. 12). The cooktop will be in a ready mode for 10 seconds. If no other key pads are touched the Cooktop Main POWER will turn OFF automatically.
To turn the Main Power OFF touch and hold the Main POWER key pad for 1 second. A beep will sound and the Power LED will turn OFF (Fig. 11).
R n
Fig. 11 | Fig. 12 |
Controls Lock Pad
This feature allows the cooktop to be locked only when the cooktop is switched to OFF.
To turn ON the Controls Loci< feature, touch and hold the LOCK key pad for 3 seconds. A beep will sound and the Loci< LED will glow (Fig. 14). Once locked, no other displays will glow and no Cooking Zones will activate (Except the hot surface message "HE" if the zone is hot).
To turn the Controls Loci< OFF, touch and hold the LOCI{ key pad for 3 seconds. A beep will sound, the Loci< LED will turn OFF (Fig. 13) and the cooktop may be used normally.
Minute Timer
The Minute Timer feature may be useful in the kitchen if a recipe calls for keeping track of time. This feature will keep track of time from 1 to 99 minutes. The
display located to the left of the Timer UP/DOWN arrow key pads will begin to count down minutes once set.
To Set the Minute Timer:
1.Set the cooktop timer to the desired time by touching the A listed under the word "TIMER". Touching and releasing the A or the V key pads will increase or decrease the Minute Timer setting by 1 minute with each key press (up to 99 minutes). You may also hold the A or V key to slew the time to your designated time.
2.Once the Timer
Note: After the timer is set, it is normal for the displayed
value to automatically go down by one minute. This is due to the fact that the display only shows the minutes remaining and does not show the countdown process in the bad< ground. For example when setting the timer for
3 minutes, the timer will start counting down at 02 rain 59 seconds, but the timer display will only show D2 minutes, not the remaining seconds.
Once the Minute Timer reaches DO a long beep will sound every 5 seconds until A and V key pads are touched at
the same time and the timer
At any time to cancel the minute Totimer,Cancelpressthethe MinuteTimer Set/OffTimer:
pad.
Fig. 15
Using the Slider Zone Control
The Slider zone control is a new and innovative way to set your cooking zone power. Heat is controlled by just the touch of a finger, resulting in a clean look uncluttered by knobs or dials. These controls are intuitive, precise and very stylish. Three methods of setting these controls are available for a better ease of use.
Powering On!OFF the Cooking Zone
Once the cooktop is active, touch the Cooking Zone On/OFF pad (Fig. 16) to activate the slider zone control.
Fig, 16
Setting the Warm & Hold Feature
When the cooking zone is on, press the Warm & Hold pad (Fig. 17) to keep food at serving temperature.
l
Fig. 17