Kenmore 3384413A manual Addi g tems , rir 9 a, Option ections, Tie Status !t dicator

Changing a Cycle or Setting

If your dishwasher has more than one wash cycle, you can change a cycle anytime during a cycle.

1.Lift the door latch to stop the cycle.

2.Turn the Cycle Control knob clockwise.

3.Check the detergant dispensers. They must be filled properly for the new cycle.

NOTE: Turning the Cycle Control knob can cause the covered Detergent Dispenser section to open and release the detergent. Check the covered section if the cycle uses detergent in both sections.

4.Close the door firmly until it latches. The dishwasher starts a new cycle.

Addi g tems © , rir 9 a e

You can add an item anytime before the main wash starts, or the Cycle Control knob reaches Light Wash/Water Miser.

1, Lift up the door latch to stop the cycle, Wait for the spraying action to stop before opening the door.

2.Open the door and add the item.

3.Close the door, but do not latch it. Wait 30 seconds for the sir in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle.

4, Close the door firmly until it latches. The dishwasher resumes the cycle.

Option ections

You can customize your cycles by pressing an option. If you change your mind, press RESET to turn the option off. Select a different option if desired.

You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.

Hi Temp Wash

Select this option to heat the water to 140°F (6O°C) dudng parts of the cycle. Heating the water helps improve washing results.

This option adds both heat and wash time to parts of the cycle. Hi Temp Wash is useful when loads contain baked-on food.

NOTE: Pots Pans automatically uses this option. Hi Temp Wash is an option with the Normal Wash, Water Miser and Light Wash cycles.

Nr Dry

Select this energy-saving option to dry without heat. Air drying is useful when loads contain plastic dinnerware that may be sensitive to high temperatures,

The dishes take longer to dry and some spotting can occur. For best drying, use a liquid rinse aid. Some items (such as plastics) may need towel drying.

NOTE: Quick Rinse and Light Wash automatically use this option.

Air Dry is an option with all other cycles.

Reset

Select Reset to change an option anytime before the selected option begins.

@

Delay Hours

Select this option to run your dishwasher at a later time or during off-peak hours.

You can delay the start of a cycle up to 6 hours.

To delay the start

1.Close the door.

2.Select a wash cycle and options.

Press the desired cycle, Turn the Cycle Control knob clockwise to the number of hours you want the dishwasher to delay the start.

The dishwasher starts the cycle in the selected number of hours. You can add items while the time is counting down.

3.Close and latch the door. The Cycle Control knob will not advance if the door is unlatched.

NOTE: Quick Rinse, Water Miser and Light Wash cycles cannot be delayed.

IMPORTANT:

•Operate your dishwasher only when you are at home.

•If your home is equipped with a water softener, do not start the dishwasher during the regeneration of the softener.

©),tie Status !t dicator

Heating

HEATING glows, and the cycle progression pauses, whenever

water is heated during a cycle. Wash or rinse action continues as the water heats.

1 HEATING

13