Kenmore 790.4906 manual Hinge Slot Door removed, Lock in normal position

Page 30

General Care & Cleaning

lge lever hook

Hinge support

Lock engaged for door removal

Figure 1

HINGE SLOT - Door removed

from the oven

Figure 2

Hinge lever

Care and Cleaning of Stainless Steel (Somemodels)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Please

refer to the table provided at the beginning of the General Care & Cleaning section in this Use & Care Guide.

Removing and Replacing the Oven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open the door to the fully opened position.

2.Pull up the lock located on both hinge supports and engage it in the hinge levers hooks (Figure 1). You may have to apply a little downward pressure on the door to pull the locks fully over the hinge lever hooks.

3.Grab the door by the sides and pull the bottom of the door up and toward you to disengage the hinge supports. Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge levers (Figure 2).

4.To clean oven door, follow the instructions provided in the General Care & Cleaning table.

To Replace Oven Door:

1.Grab the door by the sides; place the hinge supports in the hinge slots. Open the door to the fully opened position.

2.Disengage the lock from the hinge lever hooks on both sides (Figure 3). Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.

3.Close the oven door.

Lock in normal position

Figure 3

Special Door Care Instructions

Most oven doors contain glass that can break.

Read the following recommendations:

1.Do not close the oven door until all the oven racks are fully in place.

2.Do not hit the glass with pots, pans, or any other object.

3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

To remove the "hidden bake" cover

1.In order to remove the "hidden bake" cover, pull the back edge with one hand about 1/2" inch and lift up the "hidden bake" cover with both hands. (See pictu re)

2.When re-installing the "hidden bake" cover, be sure to put it all the way to the back of the oven and lay it down on the 2 shoulder screws. Then push the front edge of the cover in its place below the front bracket.

To have easier access to the "hidden bake" cover, first remove the oven door by following the instructions above.

IMPORTANT: Always replace the "hidden bake" cover before the next use.

3O

Page 29 Page 31
Image 30
Page 29 Page 31
Contents 790.4906= = Color number, nQmero de color Iii318200927 Rev. C Contents Injury to persons could result Read all instructions before using this applianceSave these instructions for future reference Do not store items of interest toProduct Record Serial Plate LocationYour Oven For prices and additional information call Maintenance AgreementsU.S.A Limitations apply. For more information about SearsFeatures Your Electric Wall OvenAt a Glance Oven Vent and Racks ArrangingMaximum Control Pad FeaturesSettings Control PadInstructionspress Setting the ClockSetting the Clock To set the clock example below forPress Setting Continuous Bake or 12 Hour Energy SavingContinuous Baking. Instructions DisplayConsumer Defined Control Instructions Press DisplayInstructions Consumer Defined Control FeaturesSetting Temperature Display --Fahrenheit or Celsius PressdisplayTo set the Preheat temperature for 350F Setting Oven ControlsSetting Preheat Db2bQTo change the Bake Temperature example Setting BakeTo set the Bake Temperature to 350F PressdisplaySetting Oven Controls Oven BakingInstructions Setting Convection BakeGeneral Convection Bake Instructions To set the oven for Convection BakeTo Set the oven to Convection Roast at 350F 176C Setting Convection RoastTo change the preset Convection Roast Temperature Instructions PressSetting the Slow Cook Feature Bake, Timed Setting TimedQQ2 Convection Bake or Timed RoastSetting Delayed Timed Bake or Delayed Timed Convection Bake Time VE,OOKSetting the Warm & Hold TM Feature To set Warm & HoldTo set Warm & Hold to turn on automatically To set the oven to broil at the default setting 550F Setting OvenSetting ControlsCook QgG@To Program ALL Other KeypadsPressdisplay To Program the Oven to Begin Baking with a stored RecipeSelf=Cleaning Adhere to the following cleaning precautionsTo Start the Self=Clean Cycle Self-CleaningWhat to Expect during Cleaning Stopping or Interrupting a Self-Cleaning CycleQQd To Start the delayed Self-Clean CycleClean ZZDStopping or interrupting a Self-Cleaning Cycle Oven CleaningAdjusting Oven Temperature ZdbPorcelain Enamel General Care & CleaningDifficuty of Major Cleaning Later Oven DoorHinge Slot Door removed Lock in normal positionCooking Table Glass shield Remove it Halogen Light BulbBefore You Call Occurrence Possible CAUSE/SOLUTIONInstallation Oven doesOccurrence Possible Cause / SolutionSolutions to Common Problems VentYour Home 8oo-488-1222Iiiiiiiiiii Canada
Top Page Image Contents