Kenmore 790.4807, 790.4809, 790.4808 manual Self-Clean Cycle Time Length

Self Cleaning

Self-Clean Cycle Time Length

Flex			feature. When		used with		a the	Delay
The cleo_pad controls the Self-Cleaning								Start pad,
a delayed Self-Cleaningcycle may		also	be	programmed.		The Flex Clean feature
allows for any Self-Cleaning	cycle	time	from	2 (2:00)	to	4 hours	(4:00).	You may

also choose the clean time in 1 minute increments (for example 2 hours and 50 minutes) by pressing the number keypads 2 50.

If you are planning to use the oven directly after a self-clean cycle remember to

allow time for the oven to cool down and the oven door to unlock. This norma!ly

takes about one hour. So a 3 hour self-clean cycle will actually take about 4 hours to complete.

_lt is recommend to use a 2 hour self-clean cycle for light soils, a 3 hour cycle for

average solls, and a 4 hour cycle for heavy solls (to assure satisfactory results).

To avoid possible burns

use care when opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape.

DO NOT force the oven door open. This can damage the automatic door locking system. Use caution and avoid possible burns when opening the door after the Self- Cleaning cycle has completed. The oven may still be VERY HOT.

INSTRUCTIONS

To start an immediate Self-Cleanlng cycle or to set a Delay

Start time of 9:00 o_clock and shut-off automatically (e×ample provided is a default 3 hour Self-CJean cycle)

1.Be sure the clock is set with the correct time of day, the oven is

EMPTY and the oven door is closed.

Fbx

2.Press cl.... "CLEAN" will flash and "3:00" HR will show in the

display (Fig. 1). The control will automatically clean for a 3 hour period (default self-cleaning cycle time). Note: If a 2 or 4 hour clean time is desired, press 2 0 0 for 2 hour or press 4 0 0 for a 4 hour clean time. Set the cleaning time based on the amount of soil: light, medium or heavy (_ See above).

3.Press _. The "DOOR LOCKED" icon will flash (Fig. 2).

4.The motor driven oven door loci< will begin to close automatically. Once the door has been locked the "DOOR LOCKi_D" indicator

light will stop flashing and remain on (Fig. 3).

Note: Allow about 15 seconds for the oven door loci< to close.

Note: If the optlonal delay Self-Cleanfeature is needed, finish steps

5-7.If Self-Clean is started immediately sklp the remaining steps and

continue with "When the Self-Clean cycle is done" on the following

page.

Delay

5.Press Start (Fig. 4). Enter the desired Self-Clean starting time using the number pads 9 0 0 (Fig. 5).

6.Press _T_. "DELAY", "DOOR LOCKED", "CLEAN" and Cooktop locked icons will remain on.

7.The control will calculate forward from the set start time to determine when the Self-Cleaning cycle should end. The Self-

Cleaning cycle will turn on automatically at the set time. At that time the icon "DELAY" will go out; the oven icon wiii come on, the start time, ';CLEAN" and "CLn" will remain in the display (Fig. 6)

PRESS

Flex

Clean

2000r400

©

Delay

Start

900

@

DISPLAY

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

28