NOT DISPENSING iCE
Check if...
All the doors are not closed completely.
The dispenser display is locked.
Ice is not selected on the dispenser.
The ice dispenser is not used often.
Ice bin is not installed correctly.
New installation.
Ice cubes are stuck in the delivery chute.
The ice dispenser is stalling while dispensing crushed ice.
Icemaker power switch in the OFF (0) position. Water supply turned off or not connected.
Then...
Ice will not dispense if any of the refrigerator doors are left open, Check if something is holding the door open,
Press and hold the Door Alarm button for 3 seconds to unlock the control panel and dispenser,
The dispenser can be set for ice or water. Make certain that the control panel is set for the proper operation. Press the dispenser Ice & Water button on the control panel to cycle through the ice and water options.
Check the ice bin for ice cubes clumping/sticking together. If they are, break up the ice cubes to allow for proper operation.
Be sure to install the ice bin firmly into position.
Wait 24 hours after icemaker installation for ice
production to begin. Wait 72 hours for full ice production. See the CONTROL PANEL FEATURES section,
Use a plastic utensil to clear the delivery chute.
Change the ice button from crushed to cubed.
If cubed ice dispenses correctly, depress the button for crushed ice and begin dispensing again.
Move the switch to the ON (I) position.
See the CONNECTING THE WATER LINE section.
NOT DISPENSING WATER
Check if...
The dispener display is locked,
New installation,
Refrigerator or freezer doors are not closed properly,
Water supply turned off or not connected, The water pressure is less than 40 psi.
Home filter or reverse osmosis system is used,
The dispenser is not set for water dispensing,
Water filter needs to be changed,
Then...
Press and hold the Door Alarm button for 3 seconds to unlock the control panel and dispenser,
Flush and fill the water system,
Water will not dispense if any of the refrigerator doors are left open,
See the CONNECTING THE WATER LINE section,
The water pressure to the home affects the flow from the dispenser,
This can decrease water pressure. It is recommended not to connect the supply line to a reverse osmosis
system for optimal operation,
The dispenser can be set for ice or water. Make certain that the control panel is set for the proper operation.
Press the dispenser button on the control panel to cycle through the ice and water options,
The filter should be changed every 6 months or more often depending on usage. The filter can become blocked over time with foreign particles and reduce the water pressure,
31