Kenmore 795.5103 To Connect Electricity, USE of Extension Cords, Recommended Grounding Method

Page 6

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance

by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous.., even if they will sit for "just a few days". If you are getting rid of your old refrigerator, please follow the instructions at right to help prevent accidents.

Your old refrigerator may have a cooling system that used CFCs (chlorofluorocarbons). CFCs are believed to harm stratospheric ozone. If you are throwing away your old refrigerator, make sure the CFC refrigerant is removed for proper disposal by a qualified servicer. If you intentionally release this CFC refrigerant, you can be subject to fines and imprisonment under provisions

IMPORTANT: Please read carefully.

TO CONNECT ELECTRICITY

Electrical Shock Hazard

FOR PERSONAL SAFETY, this appliance must be properly grounded. Have the wall outlet and the circuit checked by a qualified electrician to make sure the outlet is properly grounded.

y

3-prong grounding type wall receptacle --_..,

3-prong grounding plug

Ensure proper

ground exists before use.

USE OF EXTENSION CORDS

Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL-listed (in the United States), 3-wire grounding type appliance extension cord having a grounding type plug and outlet, and that the electrical rating of the cord be

15 amperes (minimum) and 120 volts.

Before you throw away your old refrigerator or freezer:

Take off the doors.

Leave the shelves in place so that children may not easily climb inside.

of environmental legislation. This appliance contains fluid (refrigerant, lubricant), and is made of parts and materials which are reusable and / or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework

(recycling). To recycle, please contact your local agency.

Use of an extension cord will increase the clearance needed for the back of the refrigerator. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid any hazard.

RECOMMENDED GROUNDING METHOD

The refrigerator should always be plugged into its own individual properly grounded electrical outlet rated for

115 volts, 60Hz, AC only and fused at 15 or 20 amperes. This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.

Where a standard two-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded three-prong wall outlet. Do not, under any circumstances, cut or remove the third (Ground) prong from the power cord.

NOTE: Unplug or remove power from the unit before performing any type of installation, maintenance or cleaning.

Image 6
Contents Kenmoreo Englsh / Espaiol/FranaisProtection InstallationInstallation instructions InstructionsSIDE=BY-SIDE Refrigerator Master Protection Agreements Instructions To Connect Electricity USE of Extension CordsRecommended Grounding Method Installation Base Grille InstallationUnpacking Your Refrigerator Leveling the Refrigerator Door Handle RemovalElectricShockHazard Removing and Replacing Refrigerator DoorsReinstallingtheright refrigeratordoor Door Alignment After Leveling the Door HeightConnecting the Water Line Before YOU Begin Power drillWhat YOU will Need = Drill the Hole for the Valve Shut OFF the Main Water Supply= Choose the Valve Location Fasten the Shutoff ValvePlug in the Refrigerator = Flush OUT the TubingConnect the Tubing to the Refrigerator Start the ICEiVIAKERWater Filter @ Refrigerator Shelf @ Snack Pan Prior to USE Control Panel FeaturesEnsuring Proper AiR CiRCULATiON Refrigerator and Freezer ControlsUltra ICE Door AlarmFilter Reset Control LockAdjusting Control Settings CONDITION/REASONRECOMMENDED AdjustmentFood Storage Guide Storing Frozen FoodWater and ICE Dispenser ICE Storage BIN Crisper and Crisper CoverDoor Rack and Support Refrigerator Shelves SnackpanFreezer Shelf Water Filter Filter Performance Data Sheet EcautionPower Interruptions General Cleaning TipsLight LED Replacement Door Liners and GasketsWhen YOU should SET the Icemaker Power Switch to OFF O When YOU GO on VacationWhen YOU Move Normal Sounds YOU MAY HearNoise Understanding Sounds YOU MAY HearVibration Lights do not WorkDoors will not Close Completely Compressor Motor Seems to RUN TOOMuch Cubes Produced by Icemaker are TOO SmallDoors are DiFFiCULT to Open There iS Water iN the Defrost Drain PAN Frost or ICE Crystals on Frozen FoodICE has BAD Taste or Odor Refrigerator Seems to Make TOO Much NoiseNot Dispensing iCE Not Dispensing WaterManagemylife