Kenmore 795.5108, 795.5107 manual Door Alignment, After Leveling the Door Height, Wrench 3/419 ram

Page 11

DOOR ALIGNMENT

Remove the base grille before adjusting the doors. See BASE GRILLE INSTALLATION for reference.

Two methods of door alignment are available based on the amount of adjustment needed and installation requirements.

Type 1

Adjusting tooh Fiat blade screwdriver

If the freezer compartment door is lower than the refrigerator compartment door, level them by inserting a flat blade screwdriver into the groove of the left leveling leg and rotating it clockwise.

Left leveling

legHeight difference

If the freezer compartment door is higher than the refrigerator compartment door, level them by inserting a flat blade screwdriver into the groove of the right leveling leg and rotating it clockwise.

Type 2

Adjusting tools: %6" (8 mm) wrench and

wrench 3/4"(19 ram)

Keeper nut

t Wrench

Height

 

 

difference hinge pin

"_

!_'

Down_

 

_'__

Using a ¾" (19 mm) wrench, turn the keeper nut clockwise to loosen the keeper nut.

Using a %6"(8 mm) wrench, turn the adjustment hinge pin clockwise or counterclockwise to level the refrigerator and freezer door.

After leveling the door, turn the keeper nut counterclockwise to tighten.

CAUTION: Do not overtight the door adjustment screw. The hinge pin can be pulled out. (Adjustable range of height is a maximum of ½" (1.27 cm)).

AFTER LEVELING THE DOOR HEIGHT

Confirm all legs are in contact with the floor.

Height difference _._

Right leveling leg

11

Image 11
Contents Guide dUtilisation et dEntretien Use & Care Guide Manual de Uso y CuidadoInstructions InstallationInstallation instructions ProtectionSIDE=BY=SIDE Refrigerator Kenmore Elite Limited WarrantyMaster Protection Agreements WAR, NNG Save TheseRecommended Grounding Method To Connect ElectricityUSE of Extension Cords Unpacking Your Refrigerator InstallationBase Grille Installation Handle Removal Leveling the Refrigerator DoorRemoving and Replacing Refrigerator Doors ElectricShockHazardReinstallingtheleftfreezerdoor Reinstallingtheright refrigeratordoorTheconnectors Wrench 3/419 ram Door AlignmentAfter Leveling the Door Height What YOU will Need Connecting the Water Line Before YOU BeginPower drill Fasten the Shutoff Valve Shut OFF the Main Water SupplyChoose the Valve Location = Drill the Hole for the ValveStart the ICEiVIAKER = Flush OUT the TubingConnect the Tubing to the Refrigerator Plug in the RefrigeratorWater Filter @ Refrigerator Shelf @ Snack Pan Identify your Control type Control Panel FeaturesPrior to USE Refrigerator and Freezer ControlsICE & Water Identify your icon type DisplayOffModeIcemaker Operation Personal Injury Hazard Dispenser Light Adjusting Control SettingsCONDITION/REASON Recommended Adjustment Control LockLeafy Food Storage GuideStoring Frozen Food ItemsWater and ICE Dispenser Snackpan ICE Storage BiNDoor Rack and Support Crisper and Crisper CoverRefrigerator Shelves Youcancontroltheamountof humidityinthemoistureFreezer Shelf Fixed shelfFor3secondstoturntheiconoff Waterfilter3CAUTION Filter Performance Data SheetPower Interruptions ExplosionHazard Usenon-flammablecleanerGeneral Cleaning Tips Light LED ReplacementNormal Sounds YOU MAY Hear When YOU GO on VacationWhen YOU Move When YOU should SET the Icemaker Power Switch to OFF OLights do not Work Understanding Sounds YOU MAY HearVibration NoiseDoors will not Close Completely Using Your RefrigeratorCompressor Motor Seems to RUN TOO MuchDoors are Difficult to Open Cubes Produced by Icemaker are TOO SmallRefrigerator Seems to Make TOO Much Noise Frost or ICE Crystals on Frozen FoodICE has BAD Taste or Odor There iS Water iN the Defrost Drain PANWater Not DiSPENSiNG iCENot DiSPENSiNG =800827-6655 800=361=6665 Canada For troubleshooting, product manuals and expert adviceItems like garage door openers and water heaters 18004881222 18004694663 Canada