Excessive Weight Hazard
Use two or more people to move and install the refrigerator.
Failure to do so can result in back or other injury.
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from your refrigerator before using. Do not remove any warning type labels, the model and serial number label, or the Technical Data sheet located under the front part of the refrigerator, behind the base grille.
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see the Important Safety Instructions section.
Refrigerator shelves are installed in the shipping position.
Please reinstall shelves according to your individual storage needs.
When Moving Your Refrigerator Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or walk the refrigerator when trying to move it, as floor damage could occur.
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from refrigerator.
Failure to do so can result in death, explosion or fire.
INSTALLATION
1.Avoid placing unit near heat sources, direct sunlight or moisture.
2.To minimize noise and vibration, the refrigerator MUST be installed on a solidly constructed floor.
3.Carpeting and soft tile surfaces are not recommended.
4.NEVER install the refrigerator on a platform or a weakly supported structure.
5.Install this appliance in an area where the
temperature is between 55°F (13°C)and 110°F (43°C). If the temperature around the appliance is too low or high, cooling ability may be adversely affected.
NOTE: For proper air circulation, best cooling and energy consumption results, maintain a minimum distance of 2 inches (5.08cm) from adjacent items and surfaces.
2" (5.08 cm)_
2" (5.08 cm) 4" | "_ | 2" (5.08 cm) _" | ÷ | _" |
•Be careful when you work with the hinge, base grille, stopper, etc. You may be injured.
•Do not put hands or metal sticks into air vents, base
grille or bottom of the refrigerator. You may be injured or receive an electrical shock.
BASE GRILLE INSTALLATION
To install or replace base grille:
1.Remove the 2 screws from the bottom front part of refrigerator.
2.Place base grille into position and insert and tighten screws.
To remove the base grille:
1.Open the doors. (Refrigerator and freezer).
2.Once doors are open, remove screws from base grille. Remove base grille and set safely aside.
3.Reattach screws to the base of refrigerator.