DisplayOffMode

•When the refrigerator is in the Display Off Mode, the display will remain off until a door is opened or a button is pressed. Once on, the display will remain on for 20 seconds.

•To deactivate the Display Off Mode, press and hold the Freezer Temp and Ultra Ice buttons for 5 seconds until the tone sounds. Repeat this procedure to reactivate the Display Off Mode.

Icemaker Operation

Personal Injury Hazard

Avoid contact with the moving parts of the ejector mechanism, or with the heating element that releases the cubes. DO NOT place fingers or hands on the automatic icemaking mechanism while the refrigerator is plugged in.

A newly=installed refrigerator may take 12 to 24 hours to begin making ice.

Indicator Light

		Shutoff Arm
Ice Cube	size
selector	button	Power Switch

The icemaker will produce 6 cubes per cycle, approximately 100 cubes in a 24 hour period, depending on freezer compartment temperature, room temperature, number of door openings and other operating conditions.

If the refrigerator is used before the water connection is made to the icemaker, set the power switch to OFF (O),

Throw away the first few batches of ice to allow the water line to clear.

Be sure nothing interferes with the sweep of the shutoff arm.

When the bin fills to the level of the shutoff arm, the icemaker will stop producing ice.

It is normal for several cubes to be stuck together

If ice is not used frequently, old ice cubes will become cloudy, taste stale, and shrink.

iCE & WATER

(identify your icon type)

Type 1

Type 2

You can select water or ice.

•Select Water, Crushed Ice or Cubed Ice by pressing the ICE & WATER button to the selection desired. The

Water, Crushed Ice or Cubed Ice icon will light up to indicate selection.

=_ Selecting this icon indicates that cubed ice will be dispensed when the dispenser pad is activated.

Selecting this icon indicates that water will be dispensed when the dispenser pad is activated.

Selecting this icon indicates that crushed ice will be dispensed when the dispenser pad is activated.

To dispense water or ice, gently push your cup against the dispenser pad.

NOTE: Hold your cup in place for a couple of seconds after dispensing ice or water so the last few drops go in your cup instead of on the floor.

ULTRA iCE

Type 1

Type 2

Press this button once to activate the increased ice making function. The Ultra Ice icon on the display panel will illuminate when activated. The Ultra Ice function runs the

freezer compartment at the coldest settings for a 24 hour

period to increase ice making. Press the button again to cancel the Ultra Ice function.

FILTER RESET

HOLD	3SEC	HOLD 3SEC
Type	1	Type 2

There is an indicator light for the water filter cartridge on the dispenser that will blink to indicate it is time to change the water filter. Water filters usually need to be replaced once every six months. After,_[eplacing the filter, press and

hold the Filter Reset button _ or _ for 3 seconds to

turn off the filter status light ................