Kenmore 79575559400, 3840JL2019A Crisper Cover with Lattice on Inner Surface, To replace crisper

Page 19

•Crispers with rails To remove crisper:

1. Pull drawer out to full extension.

2. Lift the front of basket up and pull straight out.

To replace crisper:

1. Push rails to the back of the compartment.

2. Insert the back corner of the basket into frame.

3.Slightly tilt up the front and push back until it snaps into place.

CRISPER COVER WITH LATTICE ON INNER SURFACE

WARNING: Be careful when handling glass cover since glass is not attached to cover.

To remove lattice:

1.Be sure glass cover is removed.

2.Turn the cover frame over. Each lattice has its own frame within the cover frame.

3.Pull left and right sides of lattice frame outward to release lattice tabs from frame. Remove lattice.

To replace lattice:

1.Pull sides of each lattice frame outward to re-insert tabs of lattice into frame.

2.Slide the cover frame back into refrigerator and securely onto frame support.

3.Place the glass cover back onto top of cover frame.

Image 19

Contents Kenmore Elite Refrigerator Freezer Features Refrigerator FeaturesFor prices and additional information call U.S.A Master Protection AgreementsPage USE of Extension Cords To Connect ElectricityRecommended Grounding Method Before YOU Throw Away Your OLD Refrigerator Or FreezerLight p.24 OPull Unpacking Your Refrigerator InstallationNext Removing Freezer Drawer Handle HOW to Remove DOOR/DRAWER HandlesRemoving Refrigerator Handle Mounted on door Keyhole slots on back of handleScrews mounted on door On back of handle HOW to Replace DOOR/DRAWER HandlesReplacing Refrigerator Door Handle Screws mounted on door Replacing Freezer Drawer HandleRemoving Refrigerator Door Removing and Replacing Refrigerator DoorsCorrectIncorrect Replacing Refrigerator Door Right DoorRemoving Pullout Drawer HOW to Remove and Install the Pullout DrawerDoor Alignment Leveling and Door AlignmentLeveling To remove the base coverEnsuring Proper AIR Circulation Setting the ControlsMargarine Adjusting Control SettingsItems How to Butter or Food Storage GuideWater Dispenser Storing Frozen FoodPackaging recommendations Wine Holder 795.7555* Model Only Refrigerator ShelvesCrisper Suprafresh Crispers with TILT-OUT CompartmentControl To remove lattice Crisper Cover with Lattice on Inner SurfaceCrispers with rails To remove crisper To replace crisperGlide N Serve Food Storage Guide Glide N ServeModular Door BIN ControlsICE BIN Dairy BINEGG BOX Tilting DoorPull OUT Drawer TILT-OUT Door BasketDurabase Divider DurabaseReplace with a new cartridge Water FilterDoor Liners and Gaskets General Cleaning TipsLight Bulb Replacement OutsideWhen YOU GO on Vacation Power InterruptionsPreparing for Vacation When YOU should SET the Icemaker Power Switch to O OFFOperation Instructions Normal Soundsyou MAY HearBefore YOU Begin Power drillChoosethe Valvelocation Flush OUT the Tubing Fasten the Shutoff ValveTighten the Pipe Clamp Connect the Tubing to the ValveRefrigerator Connect the Tubing toStart the Icemaker Plug in the RefrigeratorLights do not Work Understanding Sounds YOU MAY HearRefrigerator does not Operate Vibration or Rattling NoiseCheck Then Compressor Motor Seems to RUN TOO MuchDoors will not Close Completely Frost or ICE Crystals on Frozen FoodCubes Produced by Icemaker are TOO Small ICE has OFF-TASTE or OdorThere is Water in the Defrost Drain PAN Refrigerator Seems to Make TOO Much NoiseCheck if Then