Kenmore 79575559400, 3840JL2019A manual Connect the Tubing to, Refrigerator

Page 29

,CONNECT THE TUBING TO THE

REFRIGERATOR

Removing and Replacing Valve Cover

NOTE:

•Before making the connection to the refrigerator, be

sure the refrigerator power cord is not plugged into the wall outlet.

1. Loosen screw on top of plastic cover.

2. Lift off the cover by slightly pushing up.

4.Insert the tube into the valve and fasten with wrench as shown in the figure below.

Tubing

ACAUTION: Check to see if water dripping occurs at water line connections.

5.Bend the tube upwards and fasten it into the clamp provided to hold it in position. Replace the cover and tighten the cover screw.

Tubing

Clamp

3.Place a compression nut and a ferrule(sleeve) onto the end of tubing.

Compression Nut

(

-_	Ferrule (sleeve)

Image 29

Contents Kenmore Elite Refrigerator Freezer Features Refrigerator FeaturesFor prices and additional information call U.S.A Master Protection AgreementsPage Recommended Grounding Method To Connect ElectricityBefore YOU Throw Away Your OLD Refrigerator Or Freezer USE of Extension CordsLight p.24 OPull Next InstallationUnpacking Your Refrigerator Removing Refrigerator Handle HOW to Remove DOOR/DRAWER HandlesMounted on door Keyhole slots on back of handle Removing Freezer Drawer HandleReplacing Refrigerator Door Handle HOW to Replace DOOR/DRAWER HandlesScrews mounted on door Replacing Freezer Drawer Handle Screws mounted on door On back of handleRemoving Refrigerator Door Removing and Replacing Refrigerator DoorsCorrectIncorrect Replacing Refrigerator Door Right DoorRemoving Pullout Drawer HOW to Remove and Install the Pullout DrawerLeveling Leveling and Door AlignmentTo remove the base cover Door AlignmentEnsuring Proper AIR Circulation Setting the ControlsItems How to Butter or Adjusting Control SettingsFood Storage Guide MargarinePackaging recommendations Storing Frozen FoodWater Dispenser Wine Holder 795.7555* Model Only Refrigerator ShelvesControl Suprafresh Crispers with TILT-OUT CompartmentCrisper Crispers with rails To remove crisper Crisper Cover with Lattice on Inner SurfaceTo replace crisper To remove latticeModular Door BIN Glide N ServeControls Glide N Serve Food Storage GuideEGG BOX Dairy BINTilting Door ICE BINDurabase Divider TILT-OUT Door BasketDurabase Pull OUT DrawerReplace with a new cartridge Water FilterLight Bulb Replacement General Cleaning TipsOutside Door Liners and GasketsWhen YOU GO on Vacation Power InterruptionsOperation Instructions When YOU should SET the Icemaker Power Switch to O OFFNormal Soundsyou MAY Hear Preparing for VacationChoosethe Valvelocation Power drillBefore YOU Begin Tighten the Pipe Clamp Fasten the Shutoff ValveConnect the Tubing to the Valve Flush OUT the TubingRefrigerator Connect the Tubing toStart the Icemaker Plug in the RefrigeratorRefrigerator does not Operate Understanding Sounds YOU MAY HearVibration or Rattling Noise Lights do not WorkDoors will not Close Completely Compressor Motor Seems to RUN TOO MuchFrost or ICE Crystals on Frozen Food Check ThenThere is Water in the Defrost Drain PAN ICE has OFF-TASTE or OdorRefrigerator Seems to Make TOO Much Noise Cubes Produced by Icemaker are TOO SmallCheck if Then