Presonus Audio electronic DigiMAX LT Back Panel Basic Layout, Word Clock Out/In, Insert

CONTROLS & CONNECTIONS 2

2.2 BACK PANEL BASIC LAYOUT

115/230 VAC ~

(by internalPOWER jumpers)

20WATTS

CREATED,

DESIGNED

AND

MANUFACTURED

IN THE USA

WORD CLOCK

CHANNEL 8

CHANNEL 7

CHANNEL 6

CHANNEL 5

CHANNEL 4

CHANNEL 3

CHANNEL 2

CHANNEL 1

IN

OUT

7

5

3

1

CHANNEL INSERT POINTS

adat™

optical

interface

8

6

4

2

DIGITAL

MICROPHONE - XLR

MICROPHONE - XLR MICROPHONE - XLR

MICROPHONE - XLR MICROPHONE - XLR

MICROPHONE - XLR MICROPHONE - XLR MICROPHONE - XLR

AUDIO

LINE INPUT - TRS

LINE INPUT - TRS

LINE INPUT - TRS

LINE INPUT - TRS

LINE INPUT - TRS

LINE INPUT - TRS

LINE INPUT - TRS

LINE INPUT - TRS

OUTPUT

Digital Optical Output

An adat™ optical output (lightpipe) is provided on the rear panel of the DigiMAX LT. Eight simultaneous 24bit outputs are possible when using the optical out.

Word Clock Out/In

The word clock output and input are accessed through separate BNC con- nectors. The internal sample rate can be set to send 32k, 44.1k, or 48k. The word clock in scans the incoming information and automatically synchs to the necessary sample rate.

Insert

Each channel of the DigiMAX LT has an insert that sends and returns the signal from the associated channel. This insert can be very useful for dynamics processing (such as compressing, limiting, etc.) or for monitoring purposes by helping in overcoming the time discrepancy that may be encountered in some digital recording situations. For more detailed instructions on uses and wiring of the inserts please see the application guide at the end of the manual. This insert is wired as follows:

Sleeve

Ring

Tip

Tip Sleeve

TIP = Send

RING = Return

SLEEVE = GND

Ring

5