Kenmore 795.755564, 795.755594, 795.755544 Ensuring Proper AIR Circulation, Setting the Controls

Page 14

ENSURING PROPER AIR CIRCULATION

In order to ensure proper temperatures, air must flow between the refrigerator and freezer sections. As shown in the illustration below, air enters at top of freezer and circulates down. From bottom of freezer, air is forced up to top of refrigerator. Air enters refrigerator through top vent, then circulates and exists at bottom, where it returns to freezer.

MULTI-FLOW

•Multi-Flow means powerful and effective cooling operation. This is especially noticeable when new food is placed in the refrigerator compartment.

•If water or foreign substances enter the cool air vent while cleaning, efficiency will be lowered. In addition, if gasket is damaged, efficiency may be lowered because of escaping cool air.

Do not block any of cool air vents with food packages. If the vents are blocked, airflow will be interrupted and temperature and moisture problems may occur.

IMPORTANT: Because air circulates between both

sections, any odors formed in one section will transfer to the other. You must thoroughly clean both sections to eliminate odors. To prevent odor transfer and drying out of food, wrap or cover foods tightly. (See the Food Storage Guide section for details.)

SETTING THE CONTROLS

•Your refrigerator has a control pad on the dispenser that lets you regulate the temperature in the freezer and refrigerator compartments.

•Initially set the REFRIGERATOR CONTROL at 37°F(3°C) and the FREEZER CONTROL at 0°F(-18°C). Leave it at this setting for 24 hours (one day) to stabilize. Then adjust the compartment temperature as desired.

•Refrigerator Temp Control: 33°F/46°F(O°C to 8°C)

The lower the number setting, the colder the refrigerator compartment will become.

•Freezer Temp Control: -6°F/9°F(-21°C to -13°C) When the setting is at a lower number, the freezer compartment becomes colder. But the refrigerator compartment becomes warmer because less cold air flows into the refrigerator.

NOTE: If you want to change °F to °C or the reverse, press and hold FRZ TEMP button and REF TEMP button at the same time for 3 seconds.

•Express Freezing : Press the EXPRESS FRZ button and the LED will turn on. This function will remain activated for 24 hours and increase the cooling speed of the freezer and the amount of ice produced.

•Dispenser Lock : Press and hold the LOCK button for 3 seconds to lock the dispenser.

When it is locked, the LED will be off and the dispenser

will not operate. To unlock, press and hold the LOCK button for 3 seconds.

•Filter Reset : When the FILTER RESET LED turns on,

you have to change the water filter. Press the FILTER RESET button for 3 seconds to turn LED off. You need

to change the water filter approximately every 6 months.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Refrigerator Ownersmanual Refrigerator Features Freezer FeaturesU.S.A Master Protection Agreements For prices and additional information callPage Before YOU Throw Away Your OLD Refrigerator Or Freezer To Connect ElectricityRecommended Grounding Method USE of Extension CordsLight p.24 OPull Unpacking Your Refrigerator InstallationWhen Moving Your Refrigerator NextMounted on door Keyhole slots on back of handle HOW to Remove DOOR/DRAWER HandlesRemoving Refrigerator Handle Removing Freezer Drawer HandleScrews mounted on door Replacing Freezer Drawer Handle HOW to Replace DOOR/DRAWER HandlesReplacing Refrigerator Door Handle Screws mounted on door On back of handleRemoving and Replacing Refrigerator Doors Removing Refrigerator DoorReplacing Refrigerator Door Right Door CorrectIncorrectHOW to Remove and Install the Pullout Drawer Removing Pullout DrawerTo remove the base cover Leveling and Door AlignmentLeveling Door AlignmentSetting the Controls Ensuring Proper AIR CirculationAdjusting Control Settings Food Storage GuidePackaging recommendations Storing Frozen FoodWater Dispenser Refrigerator Shelves Wine Holder 795.7555* Model OnlyControl Suprafresh Crispers with TILT-OUT CompartmentCrisper To replace crisper Crisper Cover with Lattice on Inner SurfaceCrispers with rails To remove crisper To remove latticeControls Glide N ServeModular Door BIN To replace Glide N ServeTilting Door Dairy BINEGG BOX ICE BINDurabase TILT-OUT Door BasketDurabase Divider Pull OUT DrawerWater Filter Replace with a new cartridgeOutside General Cleaning TipsLight Bulb Replacement Door Liners and GasketsPower Interruptions When YOU GO on VacationNormal Soundsyou MAY Hear When YOU should SET the Icemaker Power Switch to O OFFOperation Instructions Preparing for VacationChoosethe Valvelocation Power drillBefore YOU Begin Connect the Tubing to the Valve Fasten the Shutoff ValveTighten the Pipe Clamp Flush OUT the TubingConnect the Tubing to RefrigeratorPlug in the Refrigerator Start the IcemakerVibration or Rattling Noise Understanding Sounds YOU MAY HearRefrigerator does not Operate Lights do not WorkFrost or ICE Crystals on Frozen Food Compressor Motor Seems to RUN TOO MuchDoors will not Close Completely Check ThenRefrigerator Seems to Make TOO Much Noise ICE has OFF-TASTE or OdorThere is Water in the Defrost Drain PAN Cubes Produced by Icemaker are TOO SmallCheck if Then

795.755564, 795.755534, 795.755524, 795.755544, 795.755594 specifications

The Kenmore line of refrigerators, specifically models 795.755594, 795.755544, 795.755524, 795.755534, and 795.755564, represents a commitment to quality, efficiency, and innovative design in home refrigeration. These models are crafted to meet the needs of modern households, offering ample storage, advanced cooling technologies, and user-friendly features.

One of the standout characteristics of these Kenmore refrigerators is their spacious interior design. With adjustable shelving and crisper drawers, users can customize their storage to accommodate a variety of food items, from large party platters to delicate fruits and vegetables. The sleek layout promotes organization, allowing easy access to all essentials while maximizing available space.

Furthermore, these models are equipped with SmartSense technology, which helps maintain optimal temperatures and humidity levels. This feature is crucial for preserving the freshness of food items for longer periods. By constantly monitoring conditions inside the refrigerator, SmartSense technology adjusts cooling and freezing cycles accordingly, preventing temperature fluctuations that can lead to spoilage.

Another notable feature is the energy-efficient design. Many of these Kenmore refrigerators come with an Energy Star certification, which means they meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only contributes to reduced energy bills but also encourages environmentally friendly practices.

Additionally, the models feature a state-of-the-art cooling system that includes a multi-air flow design. This feature ensures even cooling throughout the refrigerator, preventing warm spots and keeping all areas at a consistent temperature. Enhanced filtration systems also work to keep the air inside the refrigerator fresh, reducing odors and maintaining the quality of stored food.

In terms of convenience, the Kenmore refrigerators have user-friendly digital controls that allow for easy temperature adjustments. External ice and water dispensers add to the convenience, providing easy access to chilled water and ice without the need to open the fridge, thus maintaining its internal temperature.

In summary, the Kenmore 795 series stands out with its combination of spacious design, advanced cooling technologies, energy efficiency, and convenient features. These refrigerators are ideal for families and individuals who seek reliable performance coupled with modern conveniences, making them a smart addition to any kitchen.
Top Page Image Contents