Kenmore 795.755594 To Connect Electricity, Recommended Grounding Method, USE of Extension Cords

Page 5

Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous...even if they will sit for just a few days. If you are getting rid of your old refrigerator, please follow the instructions at right to help prevent accidents.

Your old refrigerator may have a cooling system that used CFCs (chlorofluorocarbons). CFCs are believed to harm stratospheric ozone.

IMPORTANT: Please read carefully.

TO CONNECT ELECTRICITY

Electrical Shock Hazard

FOR PERSONAL SAFETY, this appliance must be properly grounded. Have the wall outlet and the circuit checked by a qualified electrician to make sure the outlet is properly grounded.

g_r_ii!!ne g ttyp ee

_--_"_

3-prong grounding plug

RECOMMENDED GROUNDING METHOD

The refrigerator should always be plugged into its own individual properly grounded electrical outlet rated for

115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes. This provides the best performance and also prevents

overloading house wiring circuits which could cause a fire hazard from overheated wires. It is recommended that a

BEFORE YOU THROW AWAY

YOUR OLD REFRIGERATOR

OR FREEZER

•Take off the doors.

•Leave the shelves in place so that children may not easily climb inside.

If you are throwing away your old refrigerator, make sure the CFC refrigerant is removed for proper disposal by a qualified servicer. If you intentionally release this CFC refrigerant, you can be subject to fines and imprisonment under provisions of environmental legislation.

separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.

Where a standard two-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded three-prong wall outlet.

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator Control or Freezer Control, depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator Control or Freezer Control, depending on the model) to the desired setting.

USE OF EXTENSION CORDS

Because of potential safety hazards under certain conditions, we strongly recommend against the use of

an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL-listed (USA), 3-wire grounding type appliance extension cord having a grounding type plug and outlet, and that the electrical rating of the cord be 15 amperes (minimum) and 120 volts.

Use of an extension cord will increase the clearance needed for the back of the refrigerator.

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Refrigerator Ownersmanual Freezer Features Refrigerator FeaturesFor prices and additional information call U.S.A Master Protection AgreementsPage Recommended Grounding Method To Connect ElectricityBefore YOU Throw Away Your OLD Refrigerator Or Freezer USE of Extension CordsLight p.24 OPull When Moving Your Refrigerator InstallationUnpacking Your Refrigerator NextRemoving Refrigerator Handle HOW to Remove DOOR/DRAWER HandlesMounted on door Keyhole slots on back of handle Removing Freezer Drawer HandleReplacing Refrigerator Door Handle HOW to Replace DOOR/DRAWER HandlesScrews mounted on door Replacing Freezer Drawer Handle Screws mounted on door On back of handleRemoving Refrigerator Door Removing and Replacing Refrigerator DoorsCorrectIncorrect Replacing Refrigerator Door Right DoorRemoving Pullout Drawer HOW to Remove and Install the Pullout DrawerLeveling Leveling and Door AlignmentTo remove the base cover Door AlignmentEnsuring Proper AIR Circulation Setting the ControlsFood Storage Guide Adjusting Control SettingsPackaging recommendations Storing Frozen FoodWater Dispenser Wine Holder 795.7555* Model Only Refrigerator ShelvesControl Suprafresh Crispers with TILT-OUT CompartmentCrisper Crispers with rails To remove crisper Crisper Cover with Lattice on Inner SurfaceTo replace crisper To remove latticeModular Door BIN Glide N ServeControls To replace Glide N ServeEGG BOX Dairy BINTilting Door ICE BINDurabase Divider TILT-OUT Door BasketDurabase Pull OUT DrawerReplace with a new cartridge Water FilterLight Bulb Replacement General Cleaning TipsOutside Door Liners and GasketsWhen YOU GO on Vacation Power InterruptionsOperation Instructions When YOU should SET the Icemaker Power Switch to O OFFNormal Soundsyou MAY Hear Preparing for VacationChoosethe Valvelocation Power drillBefore YOU Begin Tighten the Pipe Clamp Fasten the Shutoff ValveConnect the Tubing to the Valve Flush OUT the TubingRefrigerator Connect the Tubing toStart the Icemaker Plug in the RefrigeratorRefrigerator does not Operate Understanding Sounds YOU MAY HearVibration or Rattling Noise Lights do not WorkDoors will not Close Completely Compressor Motor Seems to RUN TOO MuchFrost or ICE Crystals on Frozen Food Check ThenThere is Water in the Defrost Drain PAN ICE has OFF-TASTE or OdorRefrigerator Seems to Make TOO Much Noise Cubes Produced by Icemaker are TOO SmallCheck if Then

795.755564, 795.755534, 795.755524, 795.755544, 795.755594 specifications

The Kenmore line of refrigerators, specifically models 795.755594, 795.755544, 795.755524, 795.755534, and 795.755564, represents a commitment to quality, efficiency, and innovative design in home refrigeration. These models are crafted to meet the needs of modern households, offering ample storage, advanced cooling technologies, and user-friendly features.

One of the standout characteristics of these Kenmore refrigerators is their spacious interior design. With adjustable shelving and crisper drawers, users can customize their storage to accommodate a variety of food items, from large party platters to delicate fruits and vegetables. The sleek layout promotes organization, allowing easy access to all essentials while maximizing available space.

Furthermore, these models are equipped with SmartSense technology, which helps maintain optimal temperatures and humidity levels. This feature is crucial for preserving the freshness of food items for longer periods. By constantly monitoring conditions inside the refrigerator, SmartSense technology adjusts cooling and freezing cycles accordingly, preventing temperature fluctuations that can lead to spoilage.

Another notable feature is the energy-efficient design. Many of these Kenmore refrigerators come with an Energy Star certification, which means they meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only contributes to reduced energy bills but also encourages environmentally friendly practices.

Additionally, the models feature a state-of-the-art cooling system that includes a multi-air flow design. This feature ensures even cooling throughout the refrigerator, preventing warm spots and keeping all areas at a consistent temperature. Enhanced filtration systems also work to keep the air inside the refrigerator fresh, reducing odors and maintaining the quality of stored food.

In terms of convenience, the Kenmore refrigerators have user-friendly digital controls that allow for easy temperature adjustments. External ice and water dispensers add to the convenience, providing easy access to chilled water and ice without the need to open the fridge, thus maintaining its internal temperature.

In summary, the Kenmore 795 series stands out with its combination of spacious design, advanced cooling technologies, energy efficiency, and convenient features. These refrigerators are ideal for families and individuals who seek reliable performance coupled with modern conveniences, making them a smart addition to any kitchen.
Top Page Image Contents