PARTS OF THE SYSTEM
n filter system assembly, including mounting bracket and screws
n water supply saddle valve
n filtered water faucet, for sink or countertop mount+ ing
ote: Deluxe models include an electronic indicator faucet base and battery pack.
n 3/8" tubing and fittings to make all needed connec+ tions
n Teflon tape for fittings
MATERIALS AND TOOLS NEEDED
Dplumbers putty
Dslotted and Phillips screwdrivers
Dpliers and adjustable jaw wrench
Dhand or battery powered drill and 1/8" bit (if need ed for saddle valve installation, see page 5)
Delectric drill and 3/4" bit (type as required) if mounting hole is needed for the faucet, see pages 5 and 6
CAUTION: To avoid damaging the sink, consult a qualified plumber or installer for drilling procedures in porcelain or stainless steel.
TYPICAL UNDERSINK INSTALLATION
FIG. 1
filtered water faucet
SINK
saddle valve
HOT COLD
shutoff valve
Note: To change the fil- ter cartridge, you must turn off the water. A nearby shutoff valve is convenient. Most sinks already have shutoff valves on the supply pipes.
washer
adaptor
nut tubing
WATER
IN
insert
nut
tubing
➛
Filter I | ↕ |
|
WATER
OUT
mounting screw (2)
↕
Filter II
Note: Be sure to allow a minimum space of 1±1/2º under the system for removing the sumps, to change the cartridges.
4