Kenmore 625.38454 owner manual Incudedwater

Check and comply with local plumbing codes.

install a cold water supply fitting. The fitting must provide a leak-tight connection to the water filter 1/4" tubing, if additional tubing is required, see parts list at the end of this manual. A typical connection using the included water supply fitting is shown in Figure 2-A. An optional connection using standard plumbing fittings (not included) is

shown in Figure 2-B. in Massachusetts, plumbing codes of Massachusetts shall be adhered to. Consult with a licensed plumber

A. WATER SUPPLY FITTING (included)

1.Shut off the water supply and open faucets to drain water from the sink cold water pipe.

2.Loosen nut that connects the cold water faucet to cold water plumbing.

3.Thread water supply fitting onto pipe and reconnect nut to bottom of fitting. Be sure to use a light coating of pipe joint compound or Teflon tape (included) on outside threads. Care should be taken to prevent

cross-threading the plastic fitting.

WATER SUPPLY CONNECTION

USING INCLUDED WATER SUPPLY FITTING

faucet stud supply fitting

B. OPTIONAL PIPE FITTINGS

(compression type shown)

1.Shut off the water supply and open faucets to drain water from the sink cold water pipe.

2.Complying with plumbing codes, install a fitting on the cold water pipe to adapt 1/4" OD tubing. A typical connection is shown in Figure 2-B. If threaded fittings are used, be sure to use pipe joint compound or Teflon tape on outside threads.

WATER SUPPLY TYPICAL CONNECTION

USING COMPRESSION TYPE FITTING

(PARTS NOT INCLUDED)

1/4" O.D. tubing to Water Filter

inlet

			It	f
		t	it
threads with	_	\,....
wrap outside		incudedwater
codwaer

Teflon tape

_ 1/2" NPT

OR

e

cold waterpipe

1/4" compression

fitting

/ insert

_i_,, / ferrule

cold water

pipe1/4" tubing to "_'_-_\

Water Filter inlet

cold water shutoff valve

Figure 2-A Figure 2-B

Questions? Call The Kenmore Water Line 1-800-426-9345or visit KenmoreWater.com