This system includes
1.Allowing some slack, measure and cut a length of 1/4" tubing to connect between the supply fitting and the filter system inlet (See Figure 1). Use a sharp cutter or knife to cut the end of tubing square.
2.inspect the tubing, about 1" from end, to be sure there are no nicks, scratches or other rough spots, if needed cut the tubing again.
3.Push tubing through the collet and all the way into fit- ting. Full engagement is 11/16" for 1/4" tubing. Pull on the tubing to be sure that it is held firmly in the fit- ting.
if more tubing is required, see parts list at the end of this manual.
TO DISCONNECT TUBING:
Push the collet and hold, then pull the tubing out (See Figure 8).
NOTE:
DO NOT USE VINEGAR, OR OTHER ACID BASED CLEANERS ON THIS SYSTEM. THEY WILL DEGRADE SOME SYSTEM PARTS. ALWAYS USE SOAP AND WATER.
Tube N_ | 'X_F_,__/_ |
Cut tubing square with end of tubing round, smooth, with no cuts, nicks or flat spots.
Tube Correctly Cut
'i
Tube Partially Engaged With Fitting
Tube Fully Engaged With Fitting
Push Collet to
Remove Tubing)
Disconnect Tubing
Figure 5
Figure 6
Figure 7
Figure 8
To complete the installation, turn to page 8 and follow the filter cartridge installation steps.
Questions? Call The Kenmore Water Line