Kenmore 625.348261 owner manual Filtered WATER, Service and Regeneration, Tannin Water

Page 11

I

SECTION2

HOW YOUR WATER FILTER WORKS

B. FILTERED WATER, SERVICE AND REGENERATION

IMPORTANT: Sears water filters are sometimes installed alone in the water system, but most often other

water treating equipment is needed. Always be sure to have your water tested by a qualified testing labo-

ratory. If you need help, ask at your Sears store, or call the Kenmore Water Line, 1-800-426-9345.

TANNIN WATER

Water containing tannin has a yellowish cast (even

after softening and/or filtering). Tannin can be an

associated cause of yellow stains on washable fab-

rics, china, and plumbing fixtures. Tannins (humic

acids) are harmless organics, caused by the water

passing through peaty soil and decaying vegeta- tion.

SERVICE

When the filter is providing filtered water, it is

called "Service". During service, unfiltered water flows from the house main water pipe into the fil- ter. Inside the filter resin tank is a bed made up of

thousands of tiny, plastic resin beads. As unfil-

tered tannin passes through the bed, each bead

attracts and holds the tannin particles. It is much

like a magnet attracting and holding metals. Water

without the tannin particles flows out of the filter.

I I;l[_lJ;l=lr_J

SERVICE

WATER

IN

Res,n TankA/_'_

....- Resin Bed

Salt Storage _

il

Tank

I

REGENERATION

FILL: Salt, dissolved in water is called brine. Brine is needed to clean the tannin particles from the resin beads. To make the brine, water flows into

the salt storage area during the fill stage as shown below.

I ;l [_lJ ;] =lr=

FILL

WATER

IN

1 . Salt

I" Storage Tank

(salt not shown)

Fill Water

BRINING: During brining, the brine travels from the salt storage area, to the resin tank. Brine causes

the resin to release the tannin particles, and they are carried to the drain.

The nozzle and venturi create the suction to move

the brine, maintaining a slow flow rate for maxi- mum cleaning.

After a period of time the resin becomes coated with tannin particles and it has to be cleaned. This

cleaning is called regeneration. Regeneration is started at 12:00 AM (or other preselected time) by the timer, and consists of five cycles: (1) FILL, (2) BRINING, (3) BRINE RINSE, (4) BACKWASH, (5) FAST RINSE.

2-3

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line

Image 11
Contents Save this Manual Owners ManualSears Residential Water Filter Sears Installation Policy Sears Installation WarrantyN T E N Water Filter Start UP Safety GuidesINLET? Check List of ALL STEP-BY-STEP Guides to InstallSERVICE? SET Present Time of DAY Program the TimerSET Recharge Time TimerProgram SET Days to RechargeRechargenow Sanitizing the Water FilterVacation Faceplate Timer FeaturesHOW Your Water Filter Works Adjustable Backwash Adjustable Brine DrawAdjustable Fast Rinse Timer POWER- Outage MemoryTannin Water Filtered WATER, Service and RegenerationService ServiceAutomatic Bypass Brining / Brine RinseFast Rinse Salt Bridge Care of Your FilterChecking the Salt Storage Level and Refilling BreakingNozzle and Venturi Cleaning the Filter Resin BEDCleaning Keep the Filter from Freezing Care Your FilterProblem Cause Correction No Filtered Water Before YOU Call for Service Helpful Hints ChecklistOther Things to Know Dimensions SpecificationsOther Things to Know Wiring Schematic Service TECH. InformationAlways Make These Initial Checks First TroubleshootingManual Initiated Electronics Diagnostic Switch Valve Cycle Status DisplaysMost Likely Least Likely Manual Advance DiagnosticsAutomatic Electronic Diagnostics Possible Defect CodeServicing the Valve Rotary Valve ServiceDisassembly AssemblyWater Flow Through the Filter Valve Service CycleBrine From Salt Storage Tank Brining and Brine Rinse CyclesFast Rinse Cycle Rotor & Disc Position Switch Repair Parts KEY Part Description Problems, Questions? Call 1-800-426-9345 Kenmore Water Line KEY Part Repair Parts Repair Parts Your Home