Kenmore 625.38461 Plan Your Installation, Typical Under Sink Location, Check Space Requirements

PLAN YOUR INSTALLATION

It is recommended to read through the entire manual before beginning your installation. Follow all steps exactly. Reading this manual will also help you get all the benefits from your system.

TYPICAL UNDER SINK LOCATION

The Two-Stage Drinking Water Filter housing is normal- ly located under the kitchen and/or bathroom sink, to fil- ter the cold drinking water. See Figure 2.

CHECK SPACE REQUIREMENTS

Check size and position of items for proper installation into location chosen.

TOOLS NEEDED

Review the tools needed list. See Figure 1. Gather need- ed tools before proceeding with the installation. Read and follow the instructions provided with any tools list- ed here.

IMPORTANT: A 1-1/4” dia. hole is needed to mount the filtered water faucet. To avoid damaging the sink, con- sult a qualified plumber or installer for drilling proce- dures in porcelain or stainless steel.

Tools Needed

Phillips Screwdriver

Adjustable Wrench

Drill & 1-1/4” bit, if required

Large Adjustable Jaw Pliers or Pipe Wrench

Figure 1

SINK

cold water shutoff

NOTE: To change the filter cartridge, turn off the water and release pressure by opening the faucet. A nearby shutoff is convenient. Most sinks already have shutoff valves on the supply pipes.

7-5/8"

WATER

IN

Filter I

mounting screws (2)

WATER

OUT

Filter II