OPERATION
HOW TO USE THE
TRIMMER HEAD DRIVE LEVER
1.To engage the trimmer head, hold the con- trol bail against the handle. Move the trimmer head drive lever forward to en- gage the trimmer head. See Figure 5. The faster the engine runs, the faster the trim- mer head will rotate.
2.Once the trimmer head is rotating, push the trimmer forward to trim.
Control Bail |
Handle |
Trimmer Head |
Drive Lever |
Figure 5 |
HOW TO USE THE
THROTTLE CONTROL
1.During normal use, set the throttle con- trol lever in the FAST position to run the engine at full speed.
2.Pull the throttle control lever back to de- crease engine speed. Push the throttle control lever forward to increase engine speed.
3.To stop the engine, pull the throttle con- trol lever completely back to the STOP position.
Throttle Control |
Lever |
Figure 6 |
HOW TO USE
THE PRIMER BUTTON
1.Push the primer button five times. See Figure 7 for location. Wait approximately two seconds between each push.
NOTE: Do not use the primer button to re- start a warm engine after a short shutdown.
Primer |
Button |
Figure 7 |
9 |