Murray TM6100X5A manual HOW to Adjust Height of the Handle, HOW to SET the Height of CUT

Page 14

SERVICE AND ADJUSTMENT

HOW TO ADJUST

THE HEIGHT OF THE HANDLE

Use the knobs, on each side of the handle, to adjust the height of the handle.

1.Hold the handle with one hand and loosen both knobs until the ratchet teeth are dis- engaged. Do not remove the knobs. See Figure 12.

2.Move the handle up or down to the de- sired position, then align the ratchet teeth. Make sure both sides of the handle are level.

3.Tighten the knobs.

Handle

Ratchet

Teeth

Knob

Figure 12

HOW TO SET THE HEIGHT OF CUT

CAUTION: Before you set the

height of cut: stop the engine. Wait for all moving parts to stop. Allow the engine to cool and dis- connect the spark plug wire.

The height of cut can be set from 1-1/2 inches to 3 inches. Recommended cutting height for the average yard is 2”.

1.Use the T-wrench , found in the parts bag, to loosen the set screw shown in Figure 13.

2.Set the trimmer head at the desired height.

3.Tighten the set screw.

	Height Of Cut Positions
	Set Screw	Trimmer
	Set Screw	Head
		Head

Height Guide	T-W rench

Figure 13

F-050204L

14

Image 14

Contents Weed Trimmer MURRAY, INC. Two Year Limited Warranty Safe Operation Practices for Trimmer Safety RulesIt means Attention! Become Alert! Your Safety Is Involved General OperationIV. Service III. ChildrenSlow Fast Fuel Oil Never Operate Up Or Down Slopes. Operate Across SlopesTo Remove the Trimmer from Carton AssemblyAssembly Contents of Parts BAG Fill Crankcase With Oil HOW to Raise the HandleEngine Preparation Fill Fuel Tank With GasolineOperation HOW to Stop Trimmer HeadHOW to Stop the Engine Know Your TrimmerHOW to USE Primer Button HOW to USE Trimmer Head Drive LeverHOW to USE Throttle Control HOW to Start the Engine Trimmer TipsCustomer Responsibilities MaintenanceProduct Specifications General RecommendationsHow To Change Engine Oil How To LubricateJackshaft Assembly HOW to Change Trimmer Lines Service and AdjustmentService and Adjustment HOW to Replace the Trimmer Line HOW to Adjust Height of the Handle HOW to SET the Height of CUTHOW to Replace the Drive Belt Engine StorageTrimmer Engine does not start Trouble Shooting ChartTrouble Cause Correction Engine runs poorlyRunning Engine overheatsEngine will not stop Poor trimmingSlope Guide DegreesModel TM6100x5A Key Description 2223 Description HOW to Order Repair Parts MURRAY, INC. Lawn Mower Central Parts Distributors