Toro 38515 owner manual Setup, Unfolding the Handle

105-1980

Reorder part no. 105-3521

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure	Description	Qty.	Use
1.	No parts required	–	Unfold the handle.
	Discharge chute	1
2.	Chute handle	1	Install the discharge chute.
	Phillips head screws	3
	Washers	3
	Locknuts	3

1. Unfolding the Handle

Procedure

1. Cut the plastic tie that secures the control cable to the handle.

Note: Hold the cable taut to ensure that it stays connected at the bottom.

2. Loosen the knobs, pull out the handle bolts, and rotate the upper handle to the operating position (Figure 3).

Figure 3

5