Murray 96017000700 manual Check Battery See Fig, Install Mulcher Plate See If previously removed

Page 7

ASSEMBLY

SEAT

SHOULDER

BOLT

 

SEAT PAN

 

FLAT WASHER

 

 

02464

ADJUSTMENT

 

KNOB

 

FIG. 2

CHECK BATTERY (See Fig. 3)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions).

SEAT PAN

LABEL

TERMINAL

TERMINAL

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place motion control lever in neutral (N) position.

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Remove key from bag and start the engine (see "TO START ENGINE" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.

•Release parking brake.

•Slowly move the motion control lever forward and slowly drive tractor off skid.

•Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.

•Turn ignition key to "STOP" position.

Continue with the instructions that follow.

INSTALL MULCHER PLATE (See Fig. 4) (If previously removed)

•Raise and hold deflector shield in upright position.

•Place front of mulcher plate over front of mower deck opening and slide into place, as shown.

•Hook front latch into hole on front of mower deck.

•Hook rear latch into hole on back of mower deck.

CAUTION: Do not remove deflector shield from mower.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Always Wear EYE Protection During Operation ModelGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceIV. Towing Table of Contents Contents of Hardware Pack Unpack Carton Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Mulcher Plate See If previously removed Check Battery See FigCheck for Proper Position of ALL Belts C O N V E R T T O B a G G I N G O R DischargingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor To Transport See Figs Using the ROSTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsRunning Maintenance Check Operator Presence System TractorBlade Removal See Fig To Sharpen Blade See FigTransaxle Cooling BatteryEngine BeltsMuffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig To Install Mower See FigBelt Removal To Level Mower HousingBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigTo Remove Wheel for Repairs See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorCylinders OtherFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Mississauga, Ontario Customer Service Courtneypark Dr. East6662-661-800-1 Limitée GarantieDegrés Défectueux est Dépannage DE GuideRalenti Moteur EntreposageMoteur Réglages ET RévisionVitesses DE Boîte LA DE Mentgechan CarrossageAVANT/ Roues DES Convergence DI LA DE L’ALIGNEMENT Régler PourFrein LE Régler ET Contrôler Pour Courroie LA Remplacer PourTransmission DE MENTNETRAÎD’EN Sedeuton Courroie Acer Rempl PourDE Boîtier LE Niveau DE Mettre Pour Tondeuse DE Lame DE MENTNETRAÎD’ENTondeuse LA Enlever Pour Fig la Voir Tondeuse LA Installer PourReglages ET Revision TracteurAIR À Filtre Ligne EN Installé D’ESSENCE FiltreEntretien ’ALLUMAGE Bougie11 .FIG Transmission LA DE RefroidissementLubrification Trapézoïdales CourroiesFig la Voir Lame LA Enlever Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Utilisation Chaque Avant Recommandations LESGénérales Lubrification DE Tableau8b .FIG UtilisationTonte DE Conseils Transmission LA PurgerMoteur LE Démarrer DE Avant Tondeuse LA Utiliser Pour 8a .Fig les VoirTracteur LE Transporter Pour Pentes LES Dans Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourTeurtrac E R T O V R E S I L I T U T N E M M O C Fig la Voir Arrêter Pour02829 ’EMBRAYAGE Décharge LA MontageOU Ramassage AU Convertir Pour Retirée Auparavant SI Déchiqueteuse Plaque LA InstallerPA LA DE Tracteur LE Retirer Pour Toncar DU Tracteur LE Sortir PourLE Pour Exigés Outils LES Palette LA DE Tracteur LE Retirer DE AvantClés Montar SIN PiezasClient DU Responsabilités SommaireProduit DE Spécifications Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils LES Dans FonctionnementPentes Général FonctionnementPelouse DE Tracteur Modèle Propriétaire DU Manuel

96017000700 specifications

Murray 96017000700 is a versatile outdoor power equipment known for its robust design and efficient performance. This model is primarily a push mower, making it an ideal choice for homeowners seeking reliable and powerful lawn maintenance tools. Its features and technologies are tailored to provide an effective mowing experience, making it a popular choice among gardening enthusiasts.

One of the standout features of the Murray 96017000700 is its powerful engine. It is equipped with a reliable gas-powered engine that ensures strong performance across various mowing conditions. This engine provides the necessary torque to tackle thick grass and uneven terrains, allowing users to achieve a clean and manicured lawn effortlessly.

The mower boasts a cutting deck that is designed for durability and efficiency. Constructed from high-quality materials, the deck is both lightweight and strong, which helps in providing longevity to the product. Its cutting width allows for efficient mowing of large areas in less time, reducing the effort needed for lawn maintenance.

Another significant characteristic of the Murray 96017000700 is its adjustable cutting height feature. Users can easily adjust the height of the mower's blades to suit different grass types and lengths, ensuring a consistent cut tailored to personal preferences. This flexibility is particularly advantageous during the growing season when grass may vary significantly in height.

The ergonomic design of the mower enhances user comfort and control. Its handle is designed for ease of use, making it simple to maneuver around garden beds, trees, and other obstacles. Additionally, the mower includes a reliable starting system that minimizes the effort required to get the engine running, allowing for a hassle-free mowing experience.

In terms of maintenance, the Murray 96017000700 is specifically designed for easy servicing. Routine checks can be conducted with minimum hassle, and the mower's components are accessible for any necessary repairs or replacements. This ease of maintenance ensures that the mower remains in top working condition for years.

Overall, the Murray 96017000700 stands out in the market for its combination of power, durability, and efficiency. With its user-friendly features and solid construction, it is a valuable addition to any homeowner’s gardening toolkit, making lawn care a manageable and straightforward task. Whether tackling small yards or larger lawns, this mower remains a reliable partner for maintaining lush and healthy grass.
Top Page Image Contents