Toro 38282, 38272 manual Storage, Storing the Machine

Page 17

Important: Ensure that you install the drive belt so that it sits above the two tabs on the idler arm and below the idler arm brake (Figure 31).

7.Install the drive belt cover with the fasteners that you removed in step 1.

Storage

Storing the Machine

WARNING

•Gasoline fumes are highly flammable, explosive, and dangerous if inhaled. If you store the product in an area with an open flame, the gasoline fumes may ignite and cause an explosion.

•Do not store the machine in a house (living area), basement, or any other area where ignition sources may be present, such as hot water and space heaters, clothes dryers, furnaces, and other like appliances.

•Do not tip the machine either forward or backward with fuel in the fuel tank; otherwise, fuel may leak out of the machine.

•Do not store the machine with its handle tipped down onto the ground, because oil will leak into the engine cylinder and onto the ground, and the machine will not start or run.

1.On the last refueling of the season, add fuel stabilizer to fresh fuel as directed by the engine manufacturer.

2.Run the engine for 10 minutes to distribute the conditioned fuel through the fuel system.

3.While the engine is still warm, change the engine oil. Refer to Changing the Engine Oil.

4.Drain the fuel from the tank and carburetor by performing the following steps:

A.Loosen the fuel tank cap.

B.Unscrew, but do not remove, the small screw on the side of the carburetor fuel bowl (Figure 33) until the fuel begins to drain from the carburetor. Drain the fuel into an approved fuel container.

Important: Do not remove the carburetor bowl bolt on the bottom of the carburetor.

Figure 33

1. Carburetor bowl bolt—do 2. Small screw on carburetor not remove

C.Wait for a few minutes until the fuel has drained, then install the fuel cap and tighten the small screw on the carburetor.

5.Dispose of unused fuel properly. Recycle it according to local codes, or use it in your automobile.

6.Remove the spark plug.

7.Squirt 2 teaspoons of oil into the spark plug hole.

8.Install the spark plug by hand and then torque it to 20–22 ft-lb (27–30 N-m).

9.With the ignition key in the Off position, pull the recoil starter slowly to distribute the oil on the inside of the cylinder.

10.Disconnect the ignition key from the lanyard and store the ignition key in a safe place.

11.Clean the machine.

12.Touch up chipped surfaces with paint available from an Authorized Service Dealer. Sand affected areas before painting, and use a rust preventative to prevent the metal parts from rusting.

13.Tighten any loose fasteners. Repair or replace any damaged parts.

14.Cover the machine and store it in a clean, dry place out of the reach of children. Allow the engine to cool before storing it in any enclosure.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Power Clear 418 ZR/ZE Snowthrower SafetyIntroduction Form No -487 Rev BOperation TrainingPreparation Clearing a Clogged Discharge Chute Maintenance and StorageToro Snowthrower Safety 117-6047 Safety and Instructional Decals120-0149 117-7713Procedure Description Qty Use SetupInstalling the Handle Filling the Engine with Oil Installing the Recoil Starter HandleInstalling the Discharge Chute Assembly No Parts Required Checking the Control Cable Adjusting the Control CableAdjusting the Control Cable Checking the Engine Oil Level OperationFilling the Fuel Tank Starting the Engine Electric-start button Engaging the Rotor Blades Adjusting the Discharge Chute and Chute DeflectorDisengaging the Rotor Blades Stopping the EngineOperating Tips Preventing Freeze-up after UseSelf-propelling Snowthrower Recommended Maintenance Schedules MaintenanceMaintenance Service Maintenance Procedure Inspecting the Rotor BladesServicing the Spark Plug Remove the 4 bolts that hold the drive belt cover in place Replacing the Drive BeltStoring the Machine StoragePage Manufacturer’s Warranty Coverage Your Warranty Rights and ObligationsInstructions for Obtaining Warranty Service Owner ResponsibilitiesConditions and Products Covered Limited Warranty for Commercial UseItems and Conditions Not Covered Countries Other than the United States or Canada

38282, 38272 specifications

The Toro 38272 and 38282 are two impressive models in the Toro lineup, showcasing innovative features and technologies designed to enhance the lawn care experience.

Both models are equipped with robust 60V lithium-ion batteries, ensuring lasting power and efficiency for various lawn maintenance tasks. This battery technology not only provides the necessary power to tackle tough jobs but also supports a quieter operation compared to traditional gas-powered equipment. With no emissions, these electric options are more environmentally friendly, appealing to the growing number of eco-conscious consumers.

One of the standout features of the Toro 38272 and 38282 is their easy-start functionality. The push-button start eliminates the hassle of pulling cords associated with gas engines, offering a seamless user experience. Additionally, these models include a safety key that enhances security by preventing unauthorized use.

The cutting deck on both models is designed for maximum efficiency and versatility. With a 21-inch cutting width, they are ideally suited for medium-sized lawns, allowing users to maneuver easily around obstacles. Furthermore, these mowers offer multiple height adjustment settings, enabling users to fine-tune their preferred grass length, which is particularly beneficial during varying seasonal conditions.

Another noteworthy characteristic is the Smart Speed technology incorporated into the design of the Toro 38272 and 38282. This allows users to easily adjust the mower’s speed to cater to the terrain, whether it be slower for precision trimming or faster for clearing larger areas. This adaptability improves overall performance and enhances the user experience.

For convenience, both models feature a foldable handle design, making storage and transport easier. When not in use, they can be compactly stored away, saving valuable space in garages or sheds.

In summary, the Toro 38272 and 38282 mowers exemplify a blend of power, efficiency, and user-friendly features. Their innovative battery technology, adjustable cutting settings, and Smart Speed capability make these models a top choice for homeowners looking to maintain their lawns with ease and precision. Whether you’re a seasoned gardener or a first-time homeowner, these eco-friendly electric mowers are designed to meet your lawn care needs effectively.
Top Page Image Contents