Toro 38282, 38272 manual Setup, Installing the Handle, Procedure Description Qty Use

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure	Description	Qty.	Use
1	Oval-head bolts	2	Install the handle.
	Curved washers	2
	Handle knobs	2
2	No parts required	–	Install the recoil starter handle.
	Discharge chute assembly	1
3	Screws	2	Install the discharge chute assembly.
	Washers	2
	Locknuts	2
	Knob	1
4	Bottle of engine oil	1	Fill the engine with oil.
5	No parts required	–	Adjust the control cable.

1

Installing the Handle

Parts needed for this procedure:

2Oval-head bolts

2Curved washers

2Handle knobs

Procedure

1.Position the ends of the upper handle on the inside of the lower handle and align the holes.

2.Insert the oval-head bolts into the aligned holes, with the bolt heads on the outside of the handle (Figure 3).

	Figure 3
1. Oval-head bolt (2)	2. Curved washers and
	handle knobs

3.Install the curved washers and the handle knobs on the oval-head bolts on the inside of the handle (Figure 3) and tighten the knobs securely.

Important: Ensure that the cable is routed to the outside of the handle.

5