STYLE B
1.Remove washer and wing nut from shield.
2.Assemble parts as shown in illustration.
3.Securely tighten wing nut onto bolt.
Shield
NOTE: Remove | Line Limiter | |
and use washer and | Blade | |
wing nut from this | Wing Nut | |
bolt for assembling | ||
Washer | ||
shield. |
OPERATION
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
STYLE A | Assist Handle | STYLE B |
| Assist Handle | |
| Tube | |
| Tube | |
|
|
|
|
| Trimmer Head | |
Throttle Trigger | Shield | Throttle | Shield | |
Trigger | ||||
|
|
| ||
|
| Trimmer Head |
| |
|
|
| Line Limiter Blade |
Line Limiter Blade
ON/STOP | Spark Plug |
Switch |
|
Starter Rope |
|
Handle | Choke Lever |
| Primer Bulb |
| Fuel Mix Fill Cap |
ON/STOP SWITCH
The ON/STOP switch is used to stop engine. To stop the engine, push and release the engine ON/STOP switch.
PRIMER BULB
The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.
CHOKE
The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. After the engine attempts to start, move the choke lever to the HALF CHOKE position. Once engine has started, move the choke lever to the OFF CHOKE position.
4