Weed Eater XT 25, WT21, 530163333 Engine, Troubleshooting Table, Other, Trouble Cause Remedy

Page 9

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.

TROUBLESHOOTING TABLE

SReplace spark plug with new one of recom- mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to another.

SReplace your gasoline can if it starts to rust.

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

Engine will not

1. Engine flooded.

1. See “Starting a Flooded Engine in

 

start.

 

 

 

Operation Section.

 

 

2. Fuel tank empty.

2. Fill tank with correct fuel mixture.

 

 

3. Spark plug not firing.

3. Install new spark plug.

 

 

4. Fuel not reaching

4. Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

5. Carburetor requires

5. Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

 

 

 

 

 

Engine will

1.

Carburetor requires

1. See “Carburetor Adjustment” in

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Crankshaft seals worn.

2. Contact an authorized service dealer.

 

 

3.

Compression low.

3. Contact an authorized service dealer.

 

Engine will not

1.

Air filter dirty.

1. Clean or replace air filter.

 

accelerate,

2. Spark plug fouled.

2. Clean or replace plug

 

lacks power,

 

 

 

and regap.

 

or dies under

3.

Carburetor requires

3. Contact an authorized service dealer.

 

a load.

4.

adjustment.

4. Contact an authorized service dealer.

 

 

Carbon build-up on

 

 

 

muffler outlet screen.

 

 

 

 

5.

Compression low.

5. Contact an authorized service dealer.

 

Engine

1.

Choke partially on.

1.

Adjust choke.

 

smokes

2.

Fuel mixture incorrect.

2.

Empty fuel tank and refill with

 

excessively.

 

 

 

correct fuel mixture.

 

 

3.

Air filter dirty.

3.

Clean or replace air filter.

 

 

4.

Carburetor requires

4.

Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

Engine runs

1. Fuel mixture incorrect.

1.

See “Fueling Engine” in Operation

 

hot.

 

 

 

section.

 

 

2. Spark plug incorrect.

2.

Replace with correct spark plug.

 

 

3. Carburetor requires

3.

Contact an authorized service dealer

 

 

 

adjustment.

.

 

 

 

4. Carbon build-up on

4.

Contact an authorized service dealer.

 

 

 

muffler outlet screen.

 

 

9

Image 9
Contents Advertencia English Español FrançaisAvertissement 530163333Operator Safety Safety RulesUnit / Maintenance Safety Fuel SafetyAssembly Operation Style aStyle B HOW to Start Your Unit HOW to Stop Your UnitSwitch Before Starting Engine Fueling EngineStarting a Flooded Engine Operating InstructionsOperating Position Style a Trimmer Line AdvanceInspect and Clean Unit and Labels MaintenanceClean AIR Filter Check for Loose Fasteners and PartsStorage Service and AdjustmentsEngine Troubleshooting TableOther Trouble Cause RemedyLimited Warranty EPA/ENVIRONMENT Canada Emission Control Warranty StatementPolicy of Electrolux Home Intermediate 125 hours Extended 300 hours