Murray 11052x92D HOW to USE the Cultivator, HOW to Operate the Cultivator, How To Set The Depth

Page 11

OPERATION

HOW TO USE THE CULTIVATOR

How To Stop The Cultivator

1.Release the throttle control to stop the tines.

2.Move the ON/OFF switch, on the engine, to the OFF position.

How To Set The Depth

Your model will either have a depth stake or a depth rod to control the tilling depth and the forward speed. Set the depth stake or the depth rod to the desired tilling position as follows:

1.Remove the hairpin and the clevis pin from the depth stake or depth rod (see Figure 7).

2.Adjust the depth stake or depth rod up- ward to dig shallower or downward to dig deeper.

3.Reinstall the clevis pin and hairpin.

Depth

Stake

Clevis Pin

Hair Pin

Depth Rod

Depth Stake

 

 

Bracket

 

Clevis Pin

Depth Rod Bracket

Figure 7

HOW TO

OPERATE THE CULTIVATOR

1.Start the engine. See “How To Start The Engine”.

2.Tilt the unit back on the depth stake or depth rod until the tines are off the ground. Squeeze the throttle control all the way up against the hand grip. The engine is governor controlled and must be run at full throttle while tilling.

3.Hold the handle firmly and slowly tilt the unit forward to begin the tilling action.

4.As the tines begin to make contact with the ground, hold back on the handles so

that the tines will dig into the soil and not ride forward over the ground.

5.Avoid tilling soil that is too dry as it will pulverize and produce a dust that will not hold water. Also, tilling soil that is too wet will be hard on the machine and produce unsatisfactory clods.

6.Lowering the depth stake will slow the cultivator and make it till deeper. Raising the depth bar will allow it to move faster and till more shallow. See “How To Set The Depth Stake or Depth Rod”.

WARNING: Keep away from the rotating tines. Rotating tines can cause injury.

F–031305L

11

Image 11
Contents Model MURRAY, INC. Two Year Limited Warranty Responsibility of the Owner OWNER’S InformationSafe Operation Practices for Cultivator Safety RulesOperating Safety Fuel SafetySafe Storage Repair / Adjustments SafetySlow Fast Fuel Oil Choke OFF Half Choke Full Choke International SymbolsHOW to Assemble the Handle AssemblyAssembly Parts Packed Separately in Carton HOW to Remove the Cultivator from the CartonDle and damage the engine casing Outside of the lower handle as youTighten the knobs Checklist EYE Protection OperationKnow Your Cultivator How To Set The Depth HOW to USE the CultivatorHOW to Operate the Cultivator How To Stop The CultivatorBefore Starting the Engine How To Prepare The EngineHow To Mix The Fuel Mixture No Choke Half Choke Full Choke Choke Control HOW to Start the EngineThese areas Heavy soil 4 inch depth or greater Hints for Depth Stake or Wheel AdjustmentCultivating Tips Seed bed preparation 4 to 6 inches depthGeneral Recommendations MaintenanceProduct Specifications Customer ResponsibilitiesRemove the air vent screw see Figure LubricationFilter cover and the air filter Ment spark plugTine Removal Service and AdjustmentHOW to Remove and Install the Tines Tine InstallationEngine Shown With Air Filter Removed HOW to Adjust the CarburetorEngine StorageCultivator Trouble Cause Correction Trouble Shooting ChartModel 11052x92D KEY 485 483 323393A 480 482 484 493 481 490 496 492 494 495 491 660 650 661 662 663 946 950930 948 943 031305L MURRAY, INC. Lawn Mower Central Parts Distributors HOW to Order Repair Parts