Weed Eater 545137261 HOW to Stop Your Unit, HOW to Start Your Unit, Starting a Warm Engine

Page 5

HELPFUL TIP

If your engine switch reads “push to stop”, it is always in the ON position.

HOW TO STOP YOUR UNIT

STo stop the engine, push and hold the STOP switch in the STOP position until the engine stops.

SIf engine does not stop, move choke to the FULL CHOKE position.

HOW TO START YOUR UNIT

WARNING: The trimmer head will turn while starting the engine. Avoid any con- tact with the muffler. A hot muffler can cause serious burns.

HELPFUL TIP

If your engine still does not start after following these instructions, please call 1-800-554-6723.

STARTING A COLD ENGINE (or a warm engine after running out of fuel)

Starting Position

1.Set unit on a flat surface.

2.Slowly press the primer bulb 6 times.

3.Move choke lever to the FULL CHOKE position.

4.Squeeze the throttle trigger fully and hold through all remaining steps.

Primer Bulb

Choke

Lever

Starter Handle

5.Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times.

6.As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE position.

7.Pull starter rope sharply until engine runs, but no more than 6 pulls.

NOTE: If the engine doesn’t start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the start- er rope until the engine runs, but no more than 6 pulls. If the engine still doesn’t start, it is probably flooded. Proceed to

STARTING A FLOODED ENGINE.

8.Once the engine starts, allow it to run 10 se- conds, then move the choke lever to the RUN position. Allow the unit to run for 30 more seconds at RUN before releasing the throttle trigger.

NOTE: If engine dies with the choke le- ver in the RUN position, move the choke lever to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls.

STARTING A WARM ENGINE

1.Move the choke lever to the HALF CHOKE position.

2.Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the en- gine runs smoothly.

3.Pull starter rope sharply until engine runs, but no more than 6 pulls.

4.Allow engine to run 15 seconds, then move the choke lever to RUN.

NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing the choke lever in the RUN position; then, pull the rope to clear the engine of excess fuel. This could require pulling the starter handle many times depending on how badly the unit is flooded. If the unit still doesn’t start, refer to TROUBLESHOOTING TABLE or call 1-800-554-6723.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Manual de Instrucciones Manuel d’Instructions Operator Safety Safety RulesUnit / Maintenance Safety Fuel SafetyCutting Safety AssemblyAdjusting the Handle Transporting and StorageOperation HOW to Start Your Unit HOW to Stop Your UnitStarting a Warm Engine Starting a Flooded EngineCutting Methods Operating PositionTrimmer Line Advance Maintenance Line Replacement Service and AdjustmentsCarburetor Adjustment Engine will not idle when the throttle is re- leasedFuel System Seasonal StorageEngine OtherTroubleshooting Table Cause Remedy Ligations The U.S. Environmental Limited WarrantyConsequential Damages Weed

545137261 specifications

The Weed Eater 545137261 is a powerful and versatile string trimmer designed for homeowners and landscaping professionals alike. This model stands out for its efficient performance, user-friendly design, and innovative features that make lawn care tasks easier and more effective.

One of the key characteristics of the Weed Eater 545137261 is its lightweight design, which enhances portability and reduces user fatigue during extended periods of use. Weighing just over 10 pounds, this trimmer allows users to maneuver freely around their yards, making it an excellent choice for those with large areas to maintain.

Equipped with a powerful 25cc engine, the trimmer delivers ample power for tackling tough weeds, overgrown grass, and other vegetation. The engine employs advanced technology that not only enhances cutting efficiency but also ensures reduced emissions, making it an environmentally friendly option for homeowners looking to minimize their carbon footprint.

The Weed Eater 545137261 features a dual-line feed system that allows for quick line advancement, enabling users to keep a steady pace when trimming. This system is designed for easy string loading, which saves time and minimizes interruptions while working. Additionally, the trimmer boasts a grass deflector that aids in directing debris away from the user, improving safety during operation.

Adjustability is another significant advantage of this model. The adjustable handle positions allow users to find their most comfortable gripping angle and height, ensuring optimal control and comfort. This feature is particularly beneficial for users of varying heights, accommodating a wide range of preferences.

The design of the Weed Eater 545137261 also includes a curved shaft, which provides better balance and easier handling, especially for users who are new to string trimming. The curved shaft is an excellent choice for trimming alongside fences, walls, and flower beds without risking damage.

In conclusion, the Weed Eater 545137261 combines power, comfort, and user-friendly features to create an efficient lawn care tool. Its lightweight design, advanced engine technology, dual-line feed system, and adjustable handle make this string trimmer a reliable choice for maintaining a well-groomed yard. Whether you are a seasoned professional or a DIY enthusiast, the Weed Eater 545137261 is designed to fulfill your yard maintenance needs with ease and precision.
Top Page Image Contents