How to use the hob
Gas burners
Gas flow to the burners is adjusted by turning the knobs (illustrated in fig.2) which control the valves.
Turning the knob so that the indicator line points to the symbols printed on the panel achieves the following functions:
– Symbol ● | : Tap closed (burner off) |
– Symbol | : High (maximum) |
– Symbol | : Low (minimum) |
–The maximum aperture position permits rapid boiling of liquids, whereas the minimum aperture position allows slower warming of food or maintaining boiling conditions of liquids.
–To reduce the gas flow to minimum, rotate the knob further
–Other intermediate operating adjustments can be achieved by positioning the indicator between the maximum and minimum aperture positions, and never between the maximum aperture and closed positions.
Lighting Gas Burners
In order to light the burner, you must:
1
(fig. 3) to the full flame position marked by the symbol and hold the knob in until the flame has been lit.
In the case of a mains failure light the burner with a match or lighted taper.
2 – Wait about ten seconds after the gas lighting before releasing the knob (starting time for the valve).
3 – Adjust the gas valve to the desired power.
Important
If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.
To
If your local gas supply makes it difficult to light the burner with the knob set to maximum, set the knob to minimum and repeat the operation.
5
Fig. 2
Caution!
The cooking hob becomes very hot during operation.
Keep children well out of reach.
Fig. 3