12
Fastening the Installation Brackets (fig. 15)
–Each hob is provided with an installation kit including brackets and screws for fastening the top to fixture panels from 2 to 4 cm thick.
–Turn the hob upside down and fasten the brackets “A” to the appropriate socket holes, without tightening the screws “B” for the moment (fig. 16).
–Make sure that the brackets are fastened as shown in figure 15.
Fastening the Hob (fig. 16)
–Spread the sealing material “C” out along the fixture hole, making sure that the junctions overlap at the corners.
–Insert the hob into the hole and position it correctly.
–Adjust the position of the brackets “A” and tighten screws “B” to block the hob firmly in position.
–With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the hob. Take care not to damage the benchtop.
| A |
| A |
A |
|
| A |
| A |
Fig. 15 | A |
| C |
B
A
Fig. 16
20 mm min.
40 mm max.
