P 12/ 25
Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-6. Ignition (cont.)
DISASSEMBLING
Fly Wheel
Note: Plug cap has to be removed in order to avoid accidental start of engine.
Do not remove Plug when the nut for tightening Fly wheel is loosened to utilize air resistant in Cylinder.
(1)Attach 10 mm Hex socket bit to Impact driver. Turn M6 Hex nut counterclockwise with a Impact driver (Clutch is removed by turning clockwise). (Fig. 23)
Fig. 23
1. Turn Hex nut counterclockwise. | Hex Nut |
So the Hex nut can be removed. | |
| Fly wheel |
Piston |
|
Clutch 
| 2. Clutch is removed by |
Clutch side | turning clockwise. |
(2) Set 1R364 to Fly wheel with two M6 bolts. Tighten Both of two M6 bolts to the same depth.
Fig. 24
1R364 |
M6 Bolt |